Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Vacuum Pumping 101

pumping

Hi, not sure i understand the process just described. Do you jelq 100 3 seconds pump for 3 minutes then jelq again for 5 minutes?

Or do you pump for 3 minutes, remove pecker jelq, put back into pump for 3 then jelq again???? Sorry I would love to try that technique but I don’t understand. Could you please give instructions again. Thanks all for help on this forum…reading this forum has kept me fired up about the growth of my dick and I appreciate all advice and assistance. nala


nala

Sorry, Nala if you misunderstood

Insert the dick in the pump which has been lubed, pump to the required pressure without feeling much pain, jelqu 100 times with both hands and each jelqu will need to be 3 seconds. After the 100 jelqus, still leave dick in the pump for 3 mins w/o doing anything. Remove dick now from pump, do 100 jelqus with hands (O.K) and each stroke would need to last about 3 secs, or use sticks. Hot wrap 5 minutes.

Do this 7 times. I hope this makes it clear.

Sorry, Nala if you misunderstood here is a shorter version:-

Insert the dick in the pump which has been lubed, pump to the required pressure without much pain, jelqu 100 times and each jelqu will need to be 3 seconds. After the 100 jelqus, still leave dick in the pump for 3 mins w/o doing anything. Remove dick now from pump, do 100 jelqus with hands (O.K) and each stroke would need to last about 3 secs, or use sticks.

Do this 7 times. I hope this makes it clear.

pumping 101

flexiblepen581,

Thanks for the reply. As i understand it, you are doing a total of 700 jelques each session? How long does this take.
nala


nala

Nala, It takes approx: 1 and half hours.

Another exercise I’m doing is, while the dick is in the tube sit on a stool grab the tube with both hands do a jelque, but lean backward, while jelquing the tube forward. It’s like the squeeze and can be done about 20 jelques with a 3 second slow pull. 7 Times. Follow the same procedure to the end like the previous exercise. It’s pretty tough.

After all this, I relax in a bath, then wear a metal cock ring. It’s like coming out of a sauna.

flexiblepen581

thanks for the info. i wasn’t really sure what you meant when you were talking about the jelq and the tube but i tried pumping last night and pulled on the tube a few strokes. i think i know what you mean. i can’t tell if that is doing as much as using the hand jelq. have you seen significant results from doing this. do you have to have a tube that is tight around the johnson? my tube is a little bigger. thanks, nala


nala

I have a question for bouttime, about pressure ; My pressure gauge reads negative Bars(“-0,2”). I have tried to convert this to “Inches of Mercury”, wich I believe is the same as Hg, right?

I find that -0,2 Bars equals 6Hg. It’s important that I know that this is right, I don’t want to damage my member:-)

It feels like a very firm pull, almost a little painful.

Would appreciate it if you, or someone else(WestLA?) could help me here.


January 2009: BPEL: 8.6" EG: 5.7"

Goal for 2009: BPEL: 8.75" EG: 6"

Ultimate goal: BPEL: 9" EG: 6.5"

Odd way to measure vacuum.

Quote
Originally posted by ahund
I have a question for bouttime, about pressure ; My pressure gauge reads negative Bars(“-0,2”). I have tried to convert this to “Inches of Mercury”, wich I believe is the same as Hg, right? I find that -0,2 Bars equals 6Hg. It's important that I know that this is right, I don't want to damage my member:-) It feels like a very firm pull, almost a little painful. Would appreciate it if you, or someone else(WestLA?) could help me here.

Yes, that’s correct. A bar is a measure of pressure. Atmospheric pressure to be exact (“bar” from barometric). Negative bars is an odd way to measure vacuum, but your conversion is correct. One bar equals 29.53 inches of mercury. Remember when giving “units” of vacuum it’s not 6 Hg, it’s 6 inches Hg or 6” Hg or approximately 15 cm Hg. Saying a number with Hg and not including inches or centimeters leaves out important information.

Negative 0.2 bar is about 6 in. Hg which can be a bit painful to those not used to pumping (like me). I stay around 4 in. Hg (or -0.14 bar) and am comfortable with that. Here is a web page that you can use to convert pressure values.

Thank you, Westla, for that clarification. I was hoping you or somebody would dive in and save me on that one!


_______________

avocet8

Thanks,WestLA, getting my pump ready here:-)

I think I’ll stay around 4 -5 Hg/ inches of Mercury for a while.
feels more than enough.

By the way, I ignored the advice regarding cylinder size, bying 9” X 2 1/4”. Guess what, my precious nuts were s u c k e d in, one of them, anyway. Didn’t feel like it was supposed to happen.
So now I’m waiting for the 9” x 2”.

“Why don’t they listen?” :-)


January 2009: BPEL: 8.6" EG: 5.7"

Goal for 2009: BPEL: 8.75" EG: 6"

Ultimate goal: BPEL: 9" EG: 6.5"

HELLO,

i recently read something on a pumping site that described a method of pumping that goes like this: pump hold for a moment then release, repeat that same process with a slight more pressure each time for about 10 reps. they say this is better because the johnson will gradually become use to accepting more blood and is suppose to be better than pumping for extended periods. any thoughts? i do not know, just wanted some input. thanks, nala


nala

Nala, Ahund: Yes, by jelquing in the tube I’ve found it has increased length.Most deifintely the flaccid length.Just looking at the measurements a year ago 03/18/02 BPFL 4.5” BPEL 12cm on 03/11/03 BPFL5” BPEL 14.5cm.

Guys, what would 14.5cms be in inches? One has to be at it. Ahund, & N, I fill a 2 1/2” tube to the sides, as the dick has no where to go, it only has to move up.Now, the nuts, tie a rubber band or those colored bands which girls tie up their hair. Press the tube hard a/g the abdomen, which prevents the balls from getting in.Or the extra skin by the balls and the base of the penis.

I’m experimenting with theraband and bandages around the base, because the extra skin around the base gets sucked into the cylinder, filling the first couple of inches. That doesn’t help the girth much? I keep pressing against the pubic bone, but it gets uncomfortable after a while. Excessive lube around the base area could also cause the skin to be sucked in more easily.
I have also tried using a ring around the balls, which helps to a certain degree.
However I think the bottom line is; get the right cylinder size, pack it, then move on to the next size, which for me will be 2 1/4” x 9”. My erect girth is 14 cm, or 5.5”.

flexiblepen581, are you packing 2 1/2” cylinder with your unit or the wrapping? To pack a 2 1/2” cylinder you must have a girth of 7.85”, or 19.9 cm! Are you pumping with high pressure? What is your erect girth?

By the way, 14.5 cm equals 5.7”.

I try to follow the brilliant advice of Avocet8 found in this thread. Thanks Avocet8!


January 2009: BPEL: 8.6" EG: 5.7"

Goal for 2009: BPEL: 8.75" EG: 6"

Ultimate goal: BPEL: 9" EG: 6.5"


Last edited by ahund : 03-29-2003 at .

FLEXIBLEPEN581, ahund, thanks a million for the advice. i am pumping with a 2 inch tube. a bit large, sucking in one nut. i cant afford to buy a smaller tube so as ahund, i am working on ways to keep the nuts out of the picture while in the tube. are you hanging any weights for length or are you using the tube jelq method only for length? i have been jelquing, hanging and pumping along with use of topical testestrone (most recently) for 3 months. havent measured since start but did have some rathar intense sex with wife yesterday. she seemed very pleased and i was surprised at how much i’ve gained in girth. only from her statements.


nala

nearly man. Dash .uk.com can offer a selection of equipment to suit your requirements.I’ve been happy with their products.regards……dixie.


dixie

Top

All times are GMT. The time now is 08:10 PM.