Today marked the beginning of my hanging and clamping routine, incorporating DMSO. Exciting findings below…
Initial BPSFL: 19cm
BPSFL after the session: 21.5cm
Strain achieved: 13.16%
I experienced an astonishing level of stretch during the session. While hanging, I happened to glance in the mirror and was concerned that my vacuum cup was slipping because my penis appeared noticeably longer. However, I confirmed that the glans remained securely attached within the cup.
Something unusual occurred when I removed the vacuum cup; my glans emitted a clear liquid in large quantities. This had never happened to me before, and the liquid had no odor. I’m uncertain with what to make of this. Nonetheless, I cleaned up and proceeded with my clamping routine.
Before applying the clamp, I took the opportunity to measure my BPEL. I thought that such a significant increase in flaccid length might impact my erect length. To my surprise, I measured 20.5cm, indicating that the DMSO had significantly loosened my penis.
During the session, I employed clamping at three different positions along the shaft: first at the base, then behind the glans, and finally at mid-shaft. While it’s too early to draw definitive conclusions about its effectiveness, I plan to modify the order of clamp placement in the next session. I noticed that base clamping negatively affected my erections during the subsequent rounds of clamping. Therefore, in the next session, I will commence with clamping at the tip, followed by midshaft, and conclude with base clamping.
Additionally, after removing the clamp, I observed significant indentations on the shaft at the clamp sites, resembling the appearance of Peyronie’s disease. To alleviate these indentations, I briefly applied a gentle clamp at the base to promote blood flow and press outwards on the indentations.
Considering my inexperience with clamping, I welcome input from experienced individuals regarding possible adjustments to my routine. Clearly, DMSO has had a positive impact on my flaccid stretch.