What is the proper method for measuring your penis

Hi

I’m soon going to take my 3rd measurement, but I have some concerns about the way I measure my unit. From the beginning I measured bone pressed a little bit from the side (as it is described some where here at TP).

I rationalized that there are basically 2 purposes or principles for measuring:

A:LOOKS. This type of measuring is aim to give an genuine measurement of -how big does it looks-.

B:FEELS. Shortly said: -how big will it feel inside a vagina, or other body openings / how deep will it slide in.

To give a genuine measurement for -A- it can not be done with bone pressed measuring because it gives you between 0.5 and 1 cm extra,
Think of those guys that have extra fat around they torso/belly.

Bone pressed measure is far better to give one a clue concerning -B-, because it starts from the bone witch gives the maximum limit of how far one can push
A “rocket pocket” in her. (Of course you can just stick it in and ask her if it feels big for her, but that is not an objective and reliable measure).

So I hope you guys feel free to comment this issue, and give some ideas on it.

As I mentioned I measure bone pressed a little bit from the side (did so from the beginning), so it says more about the -B- than -A-.

The only reason for measuring your penis is to find out what size it is so that you can reliably know if your PE is working. So the measurement has to be repeatable.

The most repeatable method is:

For length:

Stand up straight. Have your penis erect and parallel to the floor. Bone press a ruler into the fat pad directly on the centre line of your penis, until it is as close to the pubic bone as you can get it without pain. A wooden ruler is often most comfortable and you can cut the end of the ruler so it has no ‘blank bit’ and starts at zero. Record the measurement.

For girth:

Either use a seamstresses tape measure, or wrap a piece of paper around your penis (either just take a mid shaft measurement, or take a mid, base and glans measurement). Where the paper crosses, mark it with a pencil and hold it against your ruler. Whatever tension you pull the paper to, make sure that is the tension you use every time. Record the measurement.

Hi
I did the measure and I’m now 6.7 in length and
4.85” in girth

Firegoat the secret about the heat is very likely as heat is an natural catalyzer (for lot of things).

Good growth Ares! Keep up the good work. :)

Yknow firegoat, you are right on the heat thing. I heat all during thru a PE session. It really loosens things up and just plain feels better in stretching mode..Lots and lots of heat…Almost uncomfortable heat…It just makes sense. What does heat do?…It expands, helps blood flow, What do you think muscle soreness ointments do. They get hot to draw nourishing blood to the area that needs repair. Its what the body wants to do naturally.

Anyway. Great work Ares88. How’s da tings down in Norway yah?

Defster :sheepdo:

Yadha, but I was thinking about the more intentional -made motivations for measuring ones unit. And I don’t talk just for myself, but like 90% of other folks.
Either way, I was referring to the more “deeper” and goal motivations for PE and the measuring.

Well even there is a global warming issue, there’s still cold weather here in Norway, and as you know cocks just shrinks away in cold places. Hehe:)