Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

The Chemical PE Thread

Hi, I’m new here, I’ve formulated a gel which contains arginine among other ingredients and helps with the arteries, veins and collagen, do you think there’s a chance of commercializing this gel, it can also work as an alternative to viagra I believe.

There are many side effects to PGE-1 in the wikipedia page:

Adverse effects

Accidental injury (Muse only)
Cardiac arrest
Congestive heart failure
Cortical proliferation of long bones
Disseminated intravascular coagulation
Injection-site haematoma
Injection-site ecchymosis (Caverject only)
Testicular (Muse only)
Prolonged erection
Penile fibrosis
Second-degree heart block
Spasm of right ventricle infundibulum
Supraventricular tachycardia
Ventricular fibrillation
Urethral burning
Uterine rupture

Any views on this?

Last edited by GeorgeGeorge : 11-05-2015 at .

Hey guys, great thread. I’m new to this site and getting ready to add a Chem protocol to my current ADS system work.

I’ve read this entire thread and much of it is over my head at this point. There is some really technical content and lots of compounds being discussed. I would appreciate any advice, support or help.

When getting started, should I add anything other than PGE-1, diluted in DMSO and BS water? Also, can anyone help with a reputable site to buy peptides? I used Trimix years ago, so I’m comfortable with the injections. Any feedback is greatly appreciated.

How much money do you spend on DMSO , PGE-1 and the like per month?

Can’t edit previous post, since you guys like injecting your penis with peptides why not do it with nucleic acids? Collagen is primarily composed from protein and RNA , RNA is composed from nucleic acids, don’t blame me if your dick falls off though.

Is this thread dead?

Guys I take PGE-1 ALL time, and never had any of those sides… Just saying…


Question re chemical PE. Could it be summarised as:

1. Get pge1 into penis
2. Get and maintain an erection for 2-4 hours
3. Subside erection

Starting Stats - 5.5 NBPEL x 5.6 EG

Current Stats - 5.7 NBPEL x 6.2 EG

Goal - 7 x 6 (with hopefully a large flaccid hang)

I have read this thread multiple times, have looked through the links, and have also done some other google searches. I still have a few questions that I’m hoping someone can help with.

I have ordered a 200mcg vial of powdered PGE1. I also ordered 30ml of bacteriostatic water. How much of each do I mix to achieve the “initial” recommended dose? How do you get withdraw the powder from the PGE1 vial without it becoming contaminated? Do you basically mix up the whole thing into a giant batch and separate it out?

Bigger after an episode of priapism

I ran across the site while trying to figure out what to do after an episode of priapism from use of trimix. Some history: I’m in my 50s, and over the past couple of years, I’ve had occasion to use trimix a number of times. The first time I used it, I required antidote for my erection to subside, and since I’ve been quite cautious, since I seem t be sensitive. A few weeks ago, I had the opportunity to use it again, but from a different source. Although I used what was supposed to be half dose, I stayed hard longer than desired, so I initially started to take some Sudafed with some resultant softening of my erection. But it didn’t go away—just not as intense. No pain, by the way, but I was pretty stiff. I should have gotten antidote at that point, but I left the place I was staying and it was nearly 12 hours before I had access to antidote to inject. After doing that, things slowly settled down, but my cock stayed somewhat stiff—and larger! Now a few weeks later, I remain mildly stiffer even when completely “flaccid,” and my cock is always chubby. I have been masturbating or having sex since then, and I get hard, but not as hard as I used to. Of course, it’s only been a couple weeks, and I didn’t take my Cialis 5 mg daily for a while. Yes, I know that this may have contributed to the priapism, but I’m on that daily for ED and to help my urinary stream. And I’ve been on it for a while—through previous uses of trimix.

Based on my reading, I’m now thinking that I may have caused a permanent size increase to my flaccid penis. I’m not sure that it’s any different when erect—it was always big, and it still is. I have not yet seen a urologist, but I plan to do that—I’ve been waiting for the “swelling” to resolve, though I think that may not happen. Not that it’s a bad thing—looks impressive, to say the least! I am thinking I will need trimix in the future to manage my somewhat worsened ED, unless it continues to resolve to a point where it’s back to normal. Which was okay, but not great.

Any thoughts from anyone who has experience with trimix or priapism, and has used it for PE?

This is a really long thread, and only one mention (via a link to a study) of MMP-1, the enzyme known for collagen degradation. I suggest we look at building blocks of elastin and collagen. Spikemoss Extract (selaginella tamariscina) is one herbal supplement that inhibits MMP-1 production.

BPC-157? Anyone?

Has anyone put the BPC-157 to use?

Doesn’t increasing blood vessel growth make sense as far as EQ goes and probably for girth gains and possibly for repair time after/between heavy hanging?

Am I completely missing something here? At very least it would seem that it would make for more blood flow through the penis, which would make for harder erections. Right?

I see it as a sure fire positive addition for girth work, but only quasi helpful for length work.

Originally Posted by inuic
Guys I take PGE-1 ALL time, and never had any of those sides.. Just saying..


I filtered mine and still had some gnarely sides when I injected. Do you heat the mixture?

Has anyone heard of the protein in sea cucumbers that softens collagen? I think they actually call it softenin.

Anyways on eBay you can get oil, cream, powder.. Etc called Gamat. Its made with sea cucumbers. I’m just nor sure if it would absorb that deeply. Any ideas?

I dont heat my PGE-1

I have actually loaded my syringe and left it for two days room temperature and it worked fine…



All times are GMT. The time now is 01:12 PM.