Extender Vacmod only Journal.

I have an Andropenis + Vacmod which I have worn for 150 hours now. Finally I got the hang of it and know the perfect tension for me to wear it without getting injuries (spotting, bruising).
Since I cannot wear it a lot of hours a day, due to work and other obligations, it will be a long haul to reach my goals.

I am measuring exactly 18cm now BPEL with 13,2EG and I won’t measure again until I’m 20cm, which is my goal. I don’t expect girth gains and if the don’t occur, it will be my focus
After this experiment. So how will I know when to measure? Well, I expect a growth of 2cm in 1000 hours, so I won’t measure until I reach 1000 hours from now, so 1150 in total.

I will post the hours I put in weekly and a guesstimate of what my size should be then. So if I putt in 20 hours the first week, I’ll be at 18,04 and so on.

Hopefully I can reach my goals at christmas next year!

Good Luck! Good idea to measure at 1000 hr.. I’m doing the same.

Yes, I think it’s less discouraging, because it is a very slow process.

By the way, I also took some pictures, but maybe I will take some with a ruler next to my unit so I can convince some non-believers IF I make any gains.
I measured it during three days at different times, so my measurements are very precise which I also find very important.

Maybe I’ll buy a Deep Blue :D

Good luck,
The only thing which could be interesting for more often measurements in this context could be BPFSL.
It can show you indicators if you are on a good way. For some after a good stretching session bpfsl goes up. BPFSL gains over time can then translate into BPEL gains

But overall its good to measure every 1000 hours.

Thank you.

When I’m 250 hours on the way (400 total) I will add 0,5 cm rod to my extender, which should keep me around stretching 1,5 cm above BPEL.

I say around because it is difficult to know. If I measure the apparatus from base till the top of the rods it comes to 23 cm now, but when I install it with the vac, the penis doesn’t get till the end of the rods like it would with a noose type extender.

Yeah thats why it could make sense to measure BPFSL .

Cause albeit 250 hours it beeing a mental milestone it does mean nothing in terms of expansion. Could be too early could be “too late” to increase rod size.

If you check BPFSL and it doesnt increase for a long time then it might make sense to already move up in tension or rods.

But also the other way around you might constantly gain BPFSL and when you ad a rod and thus increase the intensity it might be too much and would have been wiser to extend some more hours on a lower setting.

Hey TheDarkGift!

I found it best not to add rods at specific time frames. Instead, add rods when about 3/4 of the adjusting “screws” are showing.

By adjusting screws you mean the spring mechanism? Because there are no screws on an andropenis device and I cannot adjust anything.

Sunday update:

I’m at 160 hours now, so my penis guesstimate is 18,02cm now.