Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Full Package Pumping - - Length Gains?

Full Package Pumping - - Length Gains?

Lately I have done some reading on pumping and am thinking about adding it to my PE routine in the near future. At the moment, my main focus is erect length. My measure 7.3” bpel and 5.25” eg. I am wondering if a 1.75” tube for my penis or a 3” full package tube will provide more length gains? While reading, I have also encountered some individuals belief that length gains come in combination with girth gains, so the two should be worked on together with more emphasize on length. Vet pumpers, please advise me on this subject!


Started: 6.75" BPEL, 8" (20 cm) BPFSL (1/2015) x 5" (12.5 cm) EG; Current (7/2017): 8" (20 cm) BPEL, 8.2" (20.5 cm) BPFSL x 5.8" (14.5 cm) EG; Gains (7/2017): 1.25" (3.125 cm) EL, 0.2" (0.5 cm) BPFSL x 0.8" (2 cm) EG

Short-term goal: 8.25 (20.625 cm) BPEL, 8.3" (20.75 cm) BPFSL x 6" (15 cm) EG; Long-term goal: 9" (22.5 cm) BPEL x 6" EG

Xtended's Progress Report

I bought a full package 3” tube as the manufacturers said that was the way to go for length gains. I have gained length but of course it is a very slow process.. I found a 2” tube far better for girth gains and now I just about pack that when pumping around the 5hg. I don’t go any higher otherwise the skin goes black.

But like all things in PE what works for one may not work for another.

A;lso I find he 3” keeps the pumped up width for longer time than the 2”

Thanks man, I appreciate your input.


Started: 6.75" BPEL, 8" (20 cm) BPFSL (1/2015) x 5" (12.5 cm) EG; Current (7/2017): 8" (20 cm) BPEL, 8.2" (20.5 cm) BPFSL x 5.8" (14.5 cm) EG; Gains (7/2017): 1.25" (3.125 cm) EL, 0.2" (0.5 cm) BPFSL x 0.8" (2 cm) EG

Short-term goal: 8.25 (20.625 cm) BPEL, 8.3" (20.75 cm) BPFSL x 6" (15 cm) EG; Long-term goal: 9" (22.5 cm) BPEL x 6" EG

Xtended's Progress Report

I do not have any experience with full package pumping, although I will soon by buying a sun tea jar set up for full package pumping.

I have a lot of experience with my 2” diameter tube and will say that it is by far better for girth gains than length gains.

Stormy, if you do not mind me asking, what are you measurements? Is your main concentration length or girth?


Started: 6.75" BPEL, 8" (20 cm) BPFSL (1/2015) x 5" (12.5 cm) EG; Current (7/2017): 8" (20 cm) BPEL, 8.2" (20.5 cm) BPFSL x 5.8" (14.5 cm) EG; Gains (7/2017): 1.25" (3.125 cm) EL, 0.2" (0.5 cm) BPFSL x 0.8" (2 cm) EG

Short-term goal: 8.25 (20.625 cm) BPEL, 8.3" (20.75 cm) BPFSL x 6" (15 cm) EG; Long-term goal: 9" (22.5 cm) BPEL x 6" EG

Xtended's Progress Report

Full package 3” tubes:S how can I go about getting one of these?


Waiting in the queue for the 8 Inch Club

Originally Posted by mrmarshmallow
Full package 3” tubes:S how can I go about getting one of these?

For full package pumping, you might find that the 3” turns out to be a little small. I have the 4” LongJohnny from pumptoys that has a large soft gasket at the base that forms a 3” opening. This is a very comfortable set up, but a little expensive. You can also get 2-stage cylinders that are a good price at BostonPump. These cylinders feature a 3” opening at the base and then open up to 5” diameter to make sure you will have plenty of room for the boys. I am thinking about adding one of these to my collection. Once you get your balls and cock expanding all at the same time, you need a lot more room then you might think.

Xtendeddick, my measurements are 6” npb(6.25” with cock ring) and my girth varies, although it is never less than 5.25” but never more than 5.5” midshaft. My base girth can go as high as 5.75-6”. These are rested, non pumped/pe session measurements. If I were a cock ring I than I am a solid 5.5 midshaft and 6-6.5” base.

My focus is girth. Early on in my PE career, I tried for both. In time I just accepted that I was born with average in both and it would be more time effective to just focus on one. Since the general consensus amongst women is that girth beats length, it was an easy choice for me.

I’ve been on a de-conditioning break, but when I was on my routine, post pump girth with a cock ring on was almost always 6” midshaft, 6.5-7” base(although the base included some extra skin held by the cock ring, so it wasn’t totally hard; midshaft is totally hard, no sponginess/pumped type of feel). These results lasts upwards of 8-12 hours after my session. After that it would gradually go back down again. Sometimes I would have a post pump 1/4” gain in length, but not much more.

My experiences with packing are similar to petitfauns. Has been beneficial to girth, no noticable gains in length(in the cylinder I have measured 7” nbp but that has never stuck outside of cylinder).

I’m hoping that full package pumping can kickstart some new permanent gains for me.

I have been pondering this subject as well. If the cylinder is a little bit on the tight fitting side, I guess expansion would have to go in more of a length direction, since girth engorgement is somewhat restricted. Makes sense.

However, What is this “full package” tube? How do they differ from regular tubes? Link?

At roughly 5.8” base girth, I’m thinking of getting a regular 2” tube. With 5.8” base and 5.6” mid shaft girth, I’m primarily seeking length now (currently 6.5” length if I’m super turned on).

I’ve already ordered the harbor freight tools pump, now I think I’ll order a tube from boston pump, unless someone knows of a cheaper alternative.

Originally Posted by RonJeremy789
However, What is this “full package” tube? How do they differ from regular tubes? Link?


RonJeremy789:

A full package tube is simply one which is large enough to accommodate both the penis and scrotum, rather than the usual size tube for pumping just the penis. They differ from a usual tube in diameter. Regular tube sizes are diameters like 1.75 - 2.5”. When you start seeing diameters of 3+”, these are usually full package tubes. Some have a 3” or more opening, and then are shaped for an even larger diameter further down the tube. In an earlier message in this thread, Gprent notes that “I have the 4” LongJohnny from pumptoys that has a large soft gasket at the base that forms a 3” opening.” In that example, 4” is the tube diameter.

Now that you know what you’re looking for, go to the pump vendors sites and take a look. It’s tough to link directly to the full package tube in some cases, due to the way some of the web sites are constructed, so you will have to do a little bit of browsing.

In alphabetical order, here are some of the major vendors. (Am I missing any of the major players?)

www.bostonpump.com
www.lapdist.com
www.nwpumpworks.com
www.pumptoys.com
www.vacutech.com


For Lampwick, becoming hung like a donkey was the result of a total commitment.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Length gains with pumping...vegetagdPenis Pumps2003-03-2010 12:13 AM
Pumping and Hanging/Stretching for length gainsSimonClassPenis Enlargement2412-02-2006 09:50 PM
Minimal gains pumping before finding this site.wantit2bbigPenis Pumps1004-13-2006 12:11 AM
My package gains. But advice neededAlphaotegaPenis Enlargement Basics811-21-2004 04:37 AM

All times are GMT. The time now is 10:31 PM.