Attachment Questions

I have a question on attachment. I’ve been reading on thread here to attach an inch from the glans. Is there a real advantage to that? What happens if I attach to the middle or higher where it’s a bit more comfortable? If this was physics, we have a vertical rope hanging, the tension on rope is constant and equally distributed assuming the weight is straight down and not pulled at another angle. Obviously the tension near the glans is lessen but does it really matter here since we’re trying to pull the lig more off the body. Is my reasoning legit? Another question, on most hangers, the attachment mostly clamps about an inch to the glans, vacuum hangers pull on sleeve covering just about an inch or more over the glans. Why not wrap the whole shaft to avoid slippage. Is there a disadvantage wrapping the entire unit to get to a heavier comfortable tension? Thanks in advance.

The purpose of attaching an inch back has two purposes:

A) to maintain the “blood plug” at the end of the cavernosa instead of forcing the glans to take the load

and B) to give some room if/when the hanger slips. Some guys have a lot of trouble with slippage.

If you go back to the early threads and work your way forward, there was considerable discussion about both.

The CC extend under the glans. You can feel that if you tourniquet but (A) still applies because you need to trap a reasonable volume to allow for the weight to pull forward as it’s applied and that’s where (B) comes into play.

Also to avoid the nerve endings. If the hanger was closer to the glans it would be putting more pressure on the nerve endings which can lead to sensation being lost over time.

Thanks for the response but none of you address the question at hand. If the attachment was placed in middle of the shaft instead of closer to the glans, so instead of 1 inch, it’s more like 1.5 or 2 inch, even 2.5. It’ll support the slippage and the plug and comfort as well. So is it ok to go higher or is 1 inch a magic number? I understand that CC goes all the way down, but is leaving 2 inches putting so much off the table?

well, I believe the longer the area being pulled, the more lig is being elongated, so if you elongate just half your dick, you have less growth margin for part of it is not being lenghtened. I mean, PE is not only pulling the inner penis, as some call it, but also has some cell replication to it.

Try it out and see if it works. When I was compression hanging the closer I went to the base of my dick the harder it was to ensure my skin wasn’t taking any of the load. After my initial skin stretching I wanted to ensure I didn’t stretch anymore until I needed to.

The closer you attach to the base the more load the skin at the base of the shaft or between shaft & fat pad is taking and you are stretching the skin more which will lead to tenting and turkey neck. Better to attach as hich up the shaft as you can so as much of the stretch as possible is happening in the length of the shaft as this is what you are really aiming for.

Thank you all. I understand the turkey neck and i think im getting the point, i guess i just need to improve on lower attachment point and stay on that 1 inch.