Standardised measuring how to:
Reading through the posts and sooo much controversy re measuring like the HH thread (poor guy) why can’t we standardise measuring beyond what we have now ?
Far be it for me to suggest to the mods to post more detailed standard measuring but I think it would clear a lot of things up, it would be ‘Thunders approved measurement’ or T.A.M
I’m an engineer and I have the following observations
1 BPEL (bone pressed erect length)
The 2 big variables left here are, angle and measuring device, they can easily make the difference of a whole 1” !, suggest the following:
Lets measure from the top, not the side..
I would suggest a ruler, as this is a depth measure not a tape (hehe)
The angle of measuring is also hugely important, I can pick up an easy 1/2” by just going from 90 degrees to say 110 degrees pointing downward
For my measurements I use a ruler and 90degrees though I do press the slight bend flat
2 BPFL (bone pressed flaccid length)
The big difference here is weather you measure @ 90 degrees to the bod or hanging, again their is 1/2” or more of difference, also whether it’s a ruler or tape
For this one I would say hanging as that is the natural state (and what other see) on the question of ruler or tape I would again say ruler
3 erect and flaccid girth
This one is really easy, measure the fattest part of your main shaft, not the base ! The base to me seems like a cheat especially if you have a cone dick ! (With all due respect to cone dicks)
All of the above only matters when comparing your pecker to see how you stand, important ? Hell yes ! Lets admit it, of you knew the rest of the world had 2” peckers would you p.e. ? Thought not..
All the other mini measurements, head, base etc we really only care for ourselves individually, and for that it doesn’t matter to standardise because as long as you always do it the same way thats all that counts