Pumping while Clamped

It is my thought that from the first time you try clamping and the first time you try pumping, you know it works (or at least it will work). It seems there should be a way to combine these two exercises. I had a grandiose idea a while back about combining a pumping and clamping with some sort of contraption, but…

One of the key factors in growth is internal pressure which is not necessarily accomplished by pumping, but it accomplished by clamping. One of the best ways to increase internal pressure while clamped is to edge or maintain 100%-110% engorgement. Some people say they do bends or squeezes to make up for not being fully engorged, but that seems extremely dangerous. It would be good to have a steady measurable engorgement while clamped to lower the risks of injury.

I read this in a prior post, but I wanted to get everyones thoughts on using a metal cock ring while pumping. It seems that it will accomplish a clamp type effect with the steady use of constant pressure. It will also cause most of the pressure to occur internally rather than cause fluid buildup.

I would like to see what you think.

I’ve often used rings when I pump but I don’t use metal ones because they can be difficult to take off if your erection time in a cockring (30 min max) has expired. Easier for sure if your cock tapers - narrower toward the head - but not if your girth widens above where the ring rests.

Further, “clamping” with a ring heightens your chances of injury. Any pressure beyond your max is going to put you into dangerous ground.

There is, btw, no such thing as a 110% erection. At your very largest, under whatever circumstances, that is 100 % of what you are capable of at that stage of your PE.

They both do the same thing, just by different mechanisms.

Pumping increases the RELATIVE internal pressure, by DECREASING the pressure inward from the atmosphere.

Clamping increases the ABSOLUTE internal pressure.

Both have their good and bad points.

I myself have pumped while clamped and for me it was way too much, lost 1/2 inch of size overnite and had ED for weeks.

I think it is an unnecessisarily risky technique.

I think using a flexible cock ring while pumping has the benefits of allowing you to keep a better erection while in the pump, so that is a consideration.

But I don’t consider a flexible cockring (silicon, rubber, etc) clamping. Clamping can produce much higher pressures, and then can be released when needed.

A metal cockring can produce high pressures, but if it can’t be released, you may get in real trouble.

I think if you want both, then try a flexible cockring while pumping, and do clamping separately…but carefully monitor your Physiologic Indicators or your physical responses to the routine, and really be ready to cut back at the first sign of overtraining.

I personally believe that a shortest routine that gives slight expansion…FOLLOWED by a soft constrictor that doesn’t cause discoloration…worn for the whole day…will give the best and quickest girth gains.

Avocet and many others found that by using the Thera-p and similar soft constrictors, they got great flaccid gains.

I personally feel it accelerates girth gains as well, by not allowing the tissues to contract while healing.

I call it ADC or All Day Constriction…it is the girth equivalent to ADS for length gains.

Good luck

You would have to say, “110% of your normal erection” which would indicate that you have expanded past what you can normally achieve without a mechanism of expansion.

So I take it you both clamp. You must experience this…I think if I could maintain the initial clamp feel of 100% maximum or (pushing to new limits) I could make better gains. It does not feel dangerous, but comfortable. I just think after several minutes it is not at the same pressure when I started. So consequently, I think I am not working at an optimum level. Unlike Big Girtha, I can not do weekend clampathons.

I have a good taper and I think that is why the ADC is hard for me. It pushes forward to smaller diameter. I try to use it though.

How do you get a metal cock ring off? Cold water?

The real trick to clamping is to learn how to loosen the clamp just enough to do a kagal squeeze while pushing the clamp back toward your stomach…then while holding the kagal…reclamp.

If you do this correctly it will inflate the penis even further. Once you get the hang of it…it allows you to turn your dick into a purple rock if you so choose…but limit your time at this pressure if you’ve never achieved it before. The blood vessels should be given time to get used to this high pressure, don’t want to blow them out…eh?

I will sometimes not loosen the clamp and just kagel…if the penis inflates but goes right back to the size it was before the kagel…the clamp is not preventing backflow.

If it is tight enough, and you kagel without loosening it, your penis won’t expand…it will prevent blood flow in or out.

So, now that you have it tight enough…loosen it slightly, kagel…push it back toward the stomach..then reclamp.

You will see instantly when you have it right, because you will now have a larger, harder and slightly more discolored dick.

This can be done several times until you see it won’t inflate any larger, then you just do it occasionally to make sure you are at max pressure.

I think it is good to follow a max clamping session with a ADC or low pressure clamping that you can leave on for hours if you do it right.

With low level clamping, you can use thera p, soft cockrings, even a strip of tee shirt material.

You get it on slightly snug, what you should see is a heavier than normal flaccid, but little to no discoloration. In the beginning check regularly to make sure your dick isn’t turning dark and falling off.

After a while you will get the hang of it and be able to keep it partially inflated for hours.

I truly believe this will do for girth what ADS does for hanging.

I like to do ADC and clamping BTB (behind the balls) for a number of reasons. The drawback is my scrotum gets very dark from the decreased circulation when I do full pressure clamping…but I don’t go past 2 minute sets…so it is not a problem yet.

I would be even more careful for cutting oxygen off to the testicles than to the penis…the balls are probably more susceptible to tissue death than the penis…and that would be BAD!!!!

Sparky,

I really have have tree trunk dick. It can swell up to 7 1/4 after the second clamp and then go to about 5 1/4 at the circ scar. It seems that only two clamps work for me becuase they slide up to the head. I clamp as low as I can then clamp a second clamp behind the first clamp.

I can not see clamping behind the balls ouch - it would solve my problem. You only do it for two minutes?

Get the large clamp…first wrap with something like neoprene…or what ever you like, the thera-p wrap works great for me, but you can use any soft wrap.

I only use 2 minutes, because I overtrain so easily, I am slowly working up my time.

Use whatever time is good for you, just watch for the scotal color, and if it feels achy, stop immediately.

If you want a more even girth, start to jelq, it will begin to balance it out.

Thanks man.

Lots of lube, forced under the ring, will usually do it unless your upper shaft is thick. Cold compresses (or cold shower), or walking up and down stairs will usually kill an erection enough to remove the ring.

Or just a good, adrenalin panic. “OMG, my dick is gonna rot off!” :)

avocet8

I think I would get that panic feeling and it would go away instantly.

Are you still growing or just maintaining?

Just maintaining and I have to be careful not to get too lazy about that. I never lose girth gain but do have a half inch of length that will retreat if I don’t do a minimum of maintainance. Very easy to get it back in just a couple or a few good PE sessions.

I’m still getting flaccid size increase slowly; I’ve kept to a cock/ball wrapping routine. Easy for me as it’s so passive a thing to do. :)

Good to know.

The one thing that confuses me with PE is ‘overtrainning/undertrainning.’

Can you please elaborate on that?

Also will a silicone cock ring be suitable for ADC?

Bump