angle cut tube didn't turn out as expected
The 15 degree angle cut entrance on some tubes looked like a good idea. I marked a spare tube off at 15 degrees, ran it across the band saw, deburred it, and used some Shapelock plastic to radius the opening.
I’ve used it a couple of times… it’s harder to get a seal, and it wants to pull my balls up against the edge of the tube more than before.
I formed a small radius with the Shapelock. Maybe it would work better with one of the thick soft seals someof the premium tubes come with.
Maybe because I was used to it, but the perpendicular opening was more comfortable, even if it did force my member down while pumping. I might try adding some more Shapelock around the scrotum area, making a sort of elliptical opening.
I’ll stay with it for a while and see if I get used to it. Worst case, I can cut it back off square; it has several inches of extra length I’m not likely to need any time soon…