Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Wench BTC ADS

Wench BTC ADS

So much force can be applied by the wench in this fashion that it may not be appropriate for “all day stretching” but nothing else hits the ligs so hard in stealth PE that it may be an alternative to hanging if one does not have the privacy to do so.

This wraps around you like my BTC ADS device…

The CHICKENCHOKER BTC ADS Device

( which by the way only holds open microtears since it’s not strong enough to do otherwise )…but nylon straps with buckles are used instead. A penis wrap is used just like in hanging. The buckles meet right at your pubic area. The buckles were purchased at Wal-Mart in the Fabric dept. ( same place where you get the straps ).

The wench in this fashion has enough strength to impart plastic deformity as well as hold open microtears as a supplement to hanging. The first time you put it on, your eyes open up because of some serious pulling.

For the least amount of bulkiness, stitch the straps in place of the velcro and trim the “horn” off the cable clamp ( not too much or you will render it useless ). I sew with 50 pound test spectra fishing line reinforcing the knots with superglue. I sewed the female buckle on also after the photo was taken.

It’s pretty convenient to use the male buckle adjust the strength of the pull. You will find that you need much more pull when seated as compared to when standing.

Disadvantages: you’ll need a special seat cushion to sit in because of the bulkiness. I’ll try making a cushion with a hole in the middle, much like those used for fractured tailbone patients. The good thing here is not having to build an ADS attached to the steering column of your car for those 1-hour commutes to work! he-he.

This may be the only ADS that can cause the ligs to grow using only itself!!! All the other ADS hit the tunica and some have only been shown to affect flaccid length.

Since I just made it, it is unknown how long this can be used without checking for that cold glans but I did wear it for an hour straight with no problem at all.


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Damn! The photo is 892 KB so it didn’t go through!

What do I do??

hmmm….


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

I did use the jpg extension.

Still doing research…


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

ADS

Chicken,
WOW!! Its good that you did this with the Captn’s Wench. As I posted back a while ago in this thread
The Wench as an ADS I have been wearing my Captns Wench BTC every day for at least eight hours with no discomfort or discoloration whatsoever for the better part of last month. To answer your question about how long you can wear this, I think you will find the same results. I am certain that I am gaining because like you I am stretching the ligs and tunica simultaneously.

I love the idea of using the fishing twine.

If you think you have been getting a lig pull the way you have it set up now try turning the BTC Wench end for end and having the attachement strap toward the base of the shaft. It feels like I may be doubling the amount of tension on the ligs doing it this way.

Would you try this and let me know what you think?

Good luck and looking forward to hearing from you.

789


You all are still missing the point... The story was great and all but should have ass (and) some anal in it.- RWG

OK, I’ll try it that way.

I’m surprised you didn’t start a thread like I did. It is worthy of a new thread and it would’ve stood out when I searched for it.

Here’s my photo of it.

Attached Images
wench-btc-ads.jpg
(56.3 KB, 1244 views)

Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

789,

I tried it your way ( backwards wench ) and here’s what I found.

It does give a stronger pull on the base of the penis and without needing the cable clamp. BUT I can’t sit with it because my dick now faces straight down and if I have to build a seat cushion like I mentioned, the cushion would have to be over twice as thick to accomodate the protruding length of my dick. Plus I can feel the head of my dick bulging through my pants on the backside as if I have a tail! I would have to wear baggy pants to hide this.

With my method ( regular wench ) I feel the pull mostly at midshaft but I feel some at the base too and the pull is just as strong but I use the trimmed cable clamp. I know I am still getting stress at the ligs because of the BTC direction of pull.

Practically speaking, I’ll stay with my method but thanks for the feedback.

This invention is a breakthrough for me since I can only hang with regularity on weekends ( at work of all places ) for 2 months now. My gains have stalled completely since then since my ligs demand much more time and intensity.

I can now wear this ANYWHERE and feel I am actually sufficiently pulling on the ligs to cause hyperplasia of the inner penis. Also, if I set the wench close to the base of my dick, I don’t need a wrap for comfort.


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Product update1: I can wear this for about 2 hrs before having to take a break from the chafing of the material against my inner thighs. Even without a clamp it still gives a decent pull, more than enough to keep the microtears open.

I’ll try wearing this over boxers ( with my dick pulled out of the boxers ).

Product update2: While driving, I sit on 2 hard foam bars shaped like a V with the point of the V at my tailbone area. These bars are 3” thick, enough to give clearance to the Wench below. But you’ll also need to loosen your pants so that bagginess gives room for the device when you sit down.

That’s 2 more hours a day of BTC hands-free PE and here, I use the cable clamp for a serious pull - but make sure it’s not too tight so your circulation is OK for the 1 hour.
he-he Who says you don’t get anything done when commuting to and from work?? :)


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

The CC-Wench BTC ADS!

LOOK MA, NO VELCRO.

I just eliminated a lot of the undesired bulk in an awkward place for this BTC ADS.
Please note that as you make this, don’t start thinking you can hang over 5 lbs with this as a hanger because this “new” design is not made safely enough for that. It eliminates the “dorsal bridge” as Captn Hook calls it. I like to call it DORSAL DAYLIGHT because of the presence of space needed on top for safety of the dorsal nerve.

You can however hang up to 5 lbs with it.

The parts:

1. 1” nylon strap by Buckleworks - Wal-Mart
2. plastic strap buckes by Buckleworks - Wal-Mart
3. Grippers by Waxman Industries - Lowe’s
4. strong thread ( I use expensive 50 lb. test Spiderwire - spectra fishing line found in most fishing tackle stores )
5. 2 medium cable clamps - Wal-Mart.

The tools:

1. cutting knife
2. ruler
3. gas range
4. strong needle

MAKING IT:

Step 1: Cut the horns off the cable clamps making sure there is at least 1/4 inch of plastic left to the clicker slots on top.

Attached Images
cut-off-horn.jpg
(5.4 KB, 675 views)

Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Step 2: Heat the knife and cut through the front of the sides of the clamps to make room for the 1 inch wide nylon straps. This takes some deftness with a hot knife, making sure you don’t ruin other parts of the clamp.

Here’s what they should look like afterwards:

Attached Images
melt-through-sides.jpg
(6.4 KB, 653 views)

Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Look at the attachment below first before reading the next steps.

Step 3: Thread at least a 2 foot section of strap though both clamps through one side. I wear a size 31 pants. If you wear a 36 or larger, you would want to use a 3 foot strap. Thead an equal or longer strap on the other side.

Step 4: Thread on the female buckle on the far end of the shorter strap and sew its strap end onto the main strap. Thread on the male buck on the end of the longer strap. Do not sew its strap end, so you can adjust strap tension with it.

Step 5: Cut 1.25” x 2” of gripper pads. Make 2 of them.

Step 6: Position the gripper pads on the ends of the straps as in the photo. You’ll want the pads to be flush with the bottom edge of the straps - this is the edge nearest the joint of the cable clamps. This means there will be 1/4” of gripper pad protruding off the top edge of the straps.

You’ll need to see the finished product in the Member Pics Forum in this thread:

The CC-Wench BTC ADS in action!

Attached Images
threadem-n-grippem.jpg
(10.3 KB, 698 views)

Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Step 7: Bevel the ends of the gripper pads ( and trim those corners )- the ends closest to your glans and then sew this beveled end into the strap end beneath it. Include also the main strap so everything stays in place. In other words, you are sewing the gripper pad, strap end, and main strap together. The strap ends should be the same length as the gripper pads.

The length of the gripper pads can vary. I’m actually using 2.5” long gripper pads. You can get away with 2”.


Starting: 5 BPEL x 4.5 EG on 4/19/03

Latest: 6 BPEL x 5 EG on 2/17/04

Goal: 7 BPEL x 6 EG

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
The Captn's Wench Amazing ADSPirateStevePenis Extenders12412-24-2013 11:31 AM
The CHICKENCHOKER BTC ADS DevicechickenchokerPenis Hangers4006-20-2005 02:56 AM
Thoughts about ADSRisingUpTo7Penis Enlargement205-12-2005 06:31 PM
the wench as an ADSthekingPenis Hangers101-20-2004 04:05 PM

All times are GMT. The time now is 05:01 PM.