Confused about measuring

Hi,

if I measure with a ruler bone pressed until it stops, it’s 6.5/8”. This is not with all my strenght, it’s just until it stops automatically. If I press some more after the ruler has naturally stopped, I measure 6.75” (a gain of 1/8”). Then, if I press some more, with all my strength, the ruler hits 6.7/8”. That’s a total difference of 0.25”.

I have always measured like this, but at 6.75” it has stopped. But not this morning (as I mentioned above). I have a 2” fat pad, so could it be that the ruler is showing higher results because I push away ALL fat when pushing as hard as I can? Anyone else that have this “problem”? Which should I take as a real measure in your opinion?

Thanks in advance.

When I bone press, I really jam the ruler in there so I know that If I get a greater measurement the next time, it is not just because I pressed harder. So, in my opinion, I think you should press as hard as you can and take a picture. This way you can zoom in and get a very accurate number.

Sounds very locigal. :)

Simple solutions can be very good. :) Also, get confident in your measuring technique, nothing worse then finding out later that some of your gains were only from measurement errors. One common mistake (that I did as well) is only taking NBPEL measurement. I do not care how fit you are, the fat pad can vary on the best of us..

The longest length you measured is your BPEL, provided it is on top of the penis into the pubic bone. Bone pressed erect length is also known as the true “usable” length as you push against the fat pad during sex.

Thats exactly what I do too. The best way to eliminate any doubt. :)

Search for “vertical ruler”, gives you a method for getting more conistent measures over time.

I will probably be smaller if I measure this way, but I can’t say that it’s not more accurate. I’ll start measure this way.

As I suspected, I was a bit shorter when measured with a vertical ruler. 6.3/8” - a little over 0.5” smaller than before. The good part is that my fat pad wasn’t that big. 1.5” instead of 2”.