Upgraded my cylinder after 2 sessions a week for 3 weeks

I bought a 1.5” cylinder with pump and gauge at the end of 2010. I didn’t get to use it much. I finally made myself find time to use it once or twice a week for the past three weeks.

At the end of my session I put on a silicon cock ring, actually cut from a silicon sleeve. I pump up then clamp while in the cylinder. It would swell up enough I could not remove my member from the cylinder even when the air pressure was release. Even though I expended doing this I did not think it did much good since it was limited in expansion.

My gland has increase in size within the past three weeks. To the point that even though the pump is only half packed the gland around the rim is severely packed. This is even without clamping it off now. I stealth PE and last week after a nice BJ from my wife she mentioned she is having a harder time going deeper because my gland has seem to grown.

Of course to her its a mystery lol. I went ahead and ordered a 1.75”. Hoping with the added room I can pump more length. My head would get stuck in my 1.5” cylinder to the point it wouldn’t expand in length very well.

My hopes are the bigger cylinder will allow me to continue growth and to be able to cap off my pumping session with clamping for even more expansion.

If I may, it is advisable to not use constricion ring on the penis nor on the scrotum/ball sack during pumping.

I see your pic in wich you pack the tube. You really need the 1,75.

Wish you good gains.

I agree with scarsick, clamping while pumping is very dangerous. You can clamp once you ended your pumping session and edge for 10-15 minutes before your warmdown if you like. It certainly helped me.

If you have room in the cylinder is it still bad? I can take it off, it was just easier to pump erect then throw it on. But i’ll take your advice and wait until I remove the cylinder