Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Pumping Wet For Length

Pumping Wet For Length

I’m focusing some more on gaining length right now and thinking about a cheap way to focus on it while speeding up my ADS gains. I saw some cheap cylinders on eBay and I’m thinking of picking one up to use only for length gains. But what I’m wondering is how much smaller than normal should I go? I currently use a cock and balls cylinder so it’s hard to get an exact measurement, but I’d guess I have a 2.25-2.5”ish diameter pumped. Would a 2” diameter be too small to focus on length only?

Hello, look at this thread from gprent.

It takes time and devotion.

I’ve seen that thread, maybe I should rephrase the question. Going off the measurements on that chart for the scenario, lets say my base girth is 5.5. If I used a 1.75 cylinder would it speed up length gains without costing me girth?

Heh. Do the math. Yes, your cock is not a perfect circle, but as an approximation, the diameter of a 5.5 circumference is right at 1.75” already. That means you have zero room for expansion. If you’ve packed the cylinder instantly, it’s going to be hard to get longitudinal expansion.

So, no. You’d pump up and pack the cylinder just about immediately before you had the chance to develop expansion in length. You just don’t ‘slide’ and expand well in a fully packed cylinder. You’d be better off with the 2.0 inch cylinder.

For Lampwick, becoming hung like a donkey was the result of a total commitment.

Similar Threads 
ThreadStarterForumRepliesLast Post
New look at Water PumpingsparkyxPenis Pumps1905-18-2013 12:12 PM
Pumping research at the minute19052010Penis Pumps406-06-2010 04:03 PM
Pumping To Treat EDavocet8Penis Pumps701-28-2009 10:11 PM
My Marathon Shock Pumping Routine (Dick and then Balls)peforealPenis Pumps3411-27-2004 11:31 AM

All times are GMT. The time now is 01:29 AM.