Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Is Skin Contact Makes Any Problem?

Is Skin Contact Makes Any Problem?

When i am getting erection in cylinder i dont pack but my upper penis skin contacts to cylinder. Is it bad?

Attached Images
(64.8 KB, 50 views)

Last edited by ukc395 : 02-29-2016 at .

I have never had a problem when this happens and in fact, when you pump, you will eventually come to an expansion level when you begin to pack the tube and contact will occur 360 degrees around the shaft and eventually for the full length of the shaft.

Some guys have reported some skin redness or slight irritation from this contact, but that has not been my experience. Hopefully, it will also not be a problem for you.

The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

Same as Gprent, no problems with that issue what so ever, if you don’t water pump just make sure your penis is wet or lubricated it helps the skin to slide along the cylinder when increasing or decreasing the pressure.

Have a good one.

Start : BPEL 6.1", MEG 4,6". Now : BPEL 7.8", MEG 5.3"


Happens to me too and never had any negative outcome of it. A well lubricated penis and cylinder is a must in this case.

Start 6.8” x 4.7”

Now 7.5” x 4.9”

Regras do Fórum

I rub coco butter on my shaft before I start pumping. Makes everything slide in nicely and keeps my shaft skin soft and smooth. Costs about $2 at Walmart and lasts about a year.

Start 11/09 BPEL: 5.5", EG: 4.4"

Current. BPEL: 6:4", EG: 5.5"

Similar Threads 
ThreadStarterForumRepliesLast Post
Want to Stretch Shaft Skin - Advice NeededThai GuyInjuries and Treatments512-15-2008 04:18 AM
How to remove skin soreness while hangingSS4JelqPenis Hangers2301-28-2008 07:27 AM
Skin problemjim555555555Men's Sexual Health701-03-2007 07:57 PM
flaccid skin problemthevipePenis Enlargement Basics412-24-2001 10:47 AM

All times are GMT. The time now is 11:30 PM.