Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Did I purchase the right cylinder?

Did I purchase the right cylinder?

I’m all happy now that I ordered the Deluxe LA Pump that everyone’s been talking about last night. But, I’m a little worreid, I hope I didn’t make a mistake in choosing the wrong cylinder because they are VERY expensive. I should have first asked you guys prior to purchasing it. I ordered a 1 3/4 inch x 10 inch length cylinder.

My penis stats:

Base Girth: 5.25 (13.3cm)
Midshaft girth: 5.5 (14cm)
Foreshaft girth: 5.6(14.3cm)

NBP=6.75
BP=7.25

I chose the recommended 1 3/4 tube because it hits 5.5 on their chart. My goal is to get anywhere between 8-9 inches NBP. My girth goal is to get 6 to 6.25 inches; nothing more because I don’t want a girl to feel uncomfortable. So, I want to gain a little more than .5 inch in girth (to hit 6) and about 1-2 inches in length. Northstar mentioned that the circumfrence of a 1 3/4 tube is 6.5 inches around. If the tube is 6.5 around does that mean my dick is going to be 6.5?? Can I get a goal of 8nbp x 6” girth with this kind of cylinder? Do you think I should have purchased a thinner cylinder such as the 1 1/2 inch? I worry too much.


Last edited by mike2002 : 07-11-2003 at .

Whoa, dude…

The INSIDE circumference of a 1 3/4 tube is about 5.5 inches, the OUTSIDE circumference (due to the thickness of the plastic) is about 6.5 inches.

I’m really sorry I didn’t make that more clear.

Circumference = diameter (1 3/4) x pi (3.14)

That said, you’ll probably pack the cylinder pretty quickly with the tube you ordered, and make great length gains.

Then you might want to order a 2 inch tube, which would measure about 6.28 inches around (2 x 3.14).

I wanna send all you guys back to geometry class.

:)

But on another note, I’d advise against worrying about anything.

Stress hampers gains.

Grins!
N.


Keep doin' what your doin' ...

And you'll keep getting what ya got.

Got it :up: . Thank you bro! Good luck with your pump.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
DIY: Make your own flared gravel vacuum cylinder!mankiPenis Pumps910-18-2007 03:26 AM
Confusion over 2nd cylinder size.ynottryPenis Pumps910-08-2007 08:34 PM
Shapelock - custom cylinder foot in 5 minutescbwtg01Penis Pumps708-08-2007 09:01 PM
Photo-Documented DIY cylinder guide!secjayPenis Pumps1612-19-2004 04:22 PM

All times are GMT. The time now is 07:19 PM.