Curved penis and pumping

Well, I bought a pump, put it together and.no girth expansion,

I quickly found the problem, my penis curves down a bit, but this doesn’t allow equal distance on each side of the sides of my penis. Does anyone have this problem and have they found a way around it?

(I would have put this in the pumping forum but it won’t let me for whatever reason,)

Cirrow you need to have more posts before you can start threads in the other forums. I moved it for you :)

Your curvature shouldn’t affect the expansion you’re getting. You also should not be expecting a huge difference right away. Pumping, like other PE, is a very gradual process and should be begun slowly with a few short sets at lowish pressure, gradually building everything up over weeks and months.

Thanks for the quick response!

Doesn’t there need to be room on either side of my dick for it to expand in that direction? Isn’t that why tubes shaped to increase your head side are much wider near the top, to give more room to create more pressure?

I have the appropriate tube size for my penis, and it touches one side near the bottom, and touches the other side near the top, I just don’t understand or see how expansion could happen.

I also have an upwards curve, so when I pump, there is contact at the base on the bottom and also at the dorsal side of the glans, at the top. I don’t believe this contact actually results in a different amount of pressure on the different parts of the tissue, even if you intuitively might think it does.

Unfortunately I’m in no state to explain why this is, it’s probably some fairly rudimentary physics, perhaps someone else will elaborate. My understanding is that a curve doesn’t matter so long as you can still pump comfotably. There were some guys who’s curve caused too much horizontal stress which was painful and therefore needed the mushroom shaped containers, but if it’s comfortable then I wouldn’t worry :)

I don’t understand the explanation “doesn’t allow equal distance on each side of the sides.” If your penis curves down, the problem should be on top and bottom. If the problem is that the sides of your penis are touching the sides of the tube, you need an oval cylinder. Can you explain your problem differently?

I was sort of wrong in my explanation, I drew a picture here to help, nut it’s kind if terrible and isn’t representative of my penis, or a real penis, probably.

The mid part of my penis touches the side of the tube shown, and hopefully the picture illustrates how there is more pressure on some parts of the tube. (If I think the pressure works like I think it does.)

It doesn’t, that looks fine. Fine diagram by the way :)

Hey Cirrow, be careful. My curve creating contact between my mid-shaft and the inside of the tube has started to cause some irritation on the skin there. Hoping it doesn’t get worse.

Hi, guys!

I have an upward curvature also, and I´d like to “straighten” my unit a bit more. Would pumping help me with that?

Thanks

Are you using (enough) lube? My situation is similar to Tweaking’s, when I pump there is pressure on dorsal side of my glans because of upward curve so I always put lube there to prevent friction. It actually feels good that way. Without lube it would be quite painful.