ADS for 3D printers
Hello friends, first forgive my English :$ I am Spanish, recently I share this with the Spanish forum so “today” I share this with all of you, I have been designing and testing a custom ADS for a few weeks, with ideas taken from my own experience and from things I’ve seen around here. Basically, I wanted to make an ADS that would be easy to print for those users who have a 3D printer, nowadays 3d printer are becoming cheaper and cheaper so who knows… maybe some user here are interested! :D . For its design, I put some “pillars”, very simple design and easy to replicate, functional and 100% 3D printed or a viable way to have its version of hardware/similar. Well, too much “talking” haha, I share with you what I have done, also all the 3D models to be printed.
As you can see it is composed of basically four basic pieces, which I define as: Rods, Frame, base and screw.
* Rods: They are long screws with a very long pitch, each complete turn of screw advances approximately 0.66cm, for example three complete turns advance 2 cm, rods plus the base can reach 23cm long.
* Base: It is a very simple and robust, with a form of “donut” in the base to soften the support over the pubis. The inside diameter is 5 cm. The union Varillas - Base is very simple solution, where I propose the following:
-M3x14 screw and M3 nut
-Plastic clamp, those that we use for the computer cables works pretty fine, I was using then until I went to the workshop for bolt and nuts.
-I wanted to print everything, in this case I did not design it because on the internet there a tons and tons of designs, looking at portals like Thingiverse (3D Makers portal), Using as a search key “Press Pin” you will be able to find lots of solutions.
* Nut: They have no mystery, they are nuts with the same step as the rods, push the frame upwards generating tension in the penis.
* Frame: This is a piece that has a lot of potential for improvement, however it is absolutely functional and robust nowdays. Based on ADS 8mm that we know from this forum and then turning those screws around causing tension.
* Clamp: I use one that I bought in a library it’s pretty strong! however using the same philosophy of everything printed in 3d, just go to thingiverse search for “Clip” you will find tons! :D
-> How do I use it? Well, first I put talcum powder making my friend look like a geisha: D, I tie the ADS 8mm and wait a couple of minutes I find out that doing this it works better. I put my friend trough the base and grab the ADS 8mm to the frame with a clamp, fix it well and give it tension until I find the point I want.
Finally comment, I have already used a few hours (30h aprox) getting more tension than the pro ext from the biggest Chinese portal ali ali, however still in tests and accepting criticism and idea, greetings to all.
(80.4 KB, 164 views)
(38.1 KB, 122 views)
(32.2 KB, 125 views)
(30.9 KB, 112 views)