Strange shape beginning to occur with P.E.

I’ve been getting some slow but steady results with a routine that uses hanging, jelqing and fowfers.. All executed at different points in the day. I change the order every day, with hanging always coming first. Mixing those 3 is the only way I could achieve constant gains in both length and girth.

However, I noticed that the more I do, the more I notice that the width of my penis tends to get bigger near the head. To clarify, looking down at my unit from above, it is at it’s widest just before the head. That is not the natural shape of my unit, and I prefer it to be more even and for more girth to come at the base for that ‘solid’ look.

Does anyone know what this comes from or how to avoid it? Any similar experiences or names of this occurence?

Thank you,

AA

Sounds lika a baseball bat. Jelqs are probably the more guilty for that. What kind of hanger are you using?

I’m using the Bib Hanger. What causes this, and how can I adjust my technique to avoid it while adding to my base girth?

Baseball bat, straightening curve and girth at base routines
Baseball and cone shaped units
A possible way to combat the baseball shaped penis.

and there are many more. Just use the search engine. :)

Cool. Thank you Marinera, I will try some reverse jelqs for a while. Funny though, how I always kinda suspected ‘reverse somethings’ would do the trick. It’s just common sense.

Another hint for free: hanging and clamping tends to cause base girth, so this way the problem could be fixed, also.

Hmm, is there a particular kind of hanging that is best for base girth? I’ve been doing tons of BTC hanging and havn’t noticed any.

Down ward hanging with a Bib gives base girth to many.

So does BTC classify as ‘downward’?

I’d say BTC is sligthly more focused on the higher par of ligs than on the base of the penis. Downward means : just leave the weight hang down perpendicularly to the floor.

I have only done down-ward stretches but I have also seen some base girth gains from that.

Ok I got some Cable Cuffs to get some base girth going. What I don’t understand is the need for wrapping, because putting a clamp on doesn’t really seem to stress the unit enough to need protective wrapping. Whats the reason for this? I must say though, that the medium clamps aren’t quite tight enough for me to get a good clamp, unless I do use some wrapping, but barring that reason why would one need to use the wrap? Also, I was wondering if Cable Clamp brand has an ‘in between’ size, or if it’s the same sizing as the Cable Cuff brand.