How To Measure Glans

A few weeks in and I’m noticing some good PI’s.

I’m curious what is the proper way to measure the glans? My head is much larger than my shaft. Should I measure around the coronal ridge or similar to a MEG measurement just straight around?

Good question. Glans size is something that doesn’t get discussed a lot in PE. Only after hearing feedback from partners did I learn I’ve got an abnormally big head, and I would only like to make it bigger.

Personally, I would measure the same way you measure girth: at a 90 degree angle to the shaft. But place the tape at the leading edge of the coronal ridge. It’s imperfect, but every other method I can think of sounds even more imperfect.

Well my head barely squeezes into a toilet paper roll, so I guess I could call it ~5.25” since the roll is 5.5” around.

You can measure the width (side to side) with a ruler and looking at the correct angle.

Better still is a vernier caliper to meausre the glans width, you can get cheap plastic calipers and use some sandpaper to remove any sharp edges.

These days I just use thumb widths, putting two thumbs on top of erect glans and seeing how much glans is bigger than the 2 thumbs. When I started it was about 1.5 thumb widths, now it’s up around 2.2 thumbs on a good day.

I wish I know what’s my Glans Size too and how to measure it but measuring it like girth is not correct.

I tried measuring like that before but no I couldnt do it.

I was wondering the same thing but didn’t have a good way to measure. What I watch for now while pumping is packing the glans in the tube. After reading more about pumping, I realized my tube was too large. I moved down a size which packed the base nicely and I also noticed that the glans will pack after a few minutes with good heat. The glans is way more elliptical for me and it packs a 180deg arc section of the tube. That tells me that the glans is a bit wider than the tube. After pumping for a few months, I have definitely notice glans enlargement. I have watched the glans slowly go from a couple of contact points on the cylinder to a full 3/8” contact arc around 180deg of the tube. Assuming you are using the correct tube size, pumping is a great way to watch small progressions. At this point in PE, I don’t know if the gains would remain if I stopped pumping. I have a couple of contact points now mid shaft and I am excited to see if I can pack the full tube by the end of the year.

Measure the length and the width with a ruler, that’s my suggestion.

If you want to know the max circumference of your glans, then measure around the coronal ridge. Since your head is larger then the shaft, that is the dimension that counts for getting into tight spaces. :)