when to get a bigger cylinder

Hey guys, I have a cylinder that is about 7.5” and when fully erect in the pump I end up having a deep circle indention at the end of my head from the thing the hose connects too. Would going to a longer cylinder do anything for me as to possible length gains? As far as girth I have about an 1/8” on each side so I think I am Ok there.

Thanks!

If you’re bumping up against the end of the cylinder, you need a longer cylinder.

One temporary measure to extend the use of your current tube would be to add a cushion or ‘donut’ at the end of the cylinder; that would give you a little more effective length until you can get a longer cylinder.

What about width? I find that after my session, outside of my glans, almost everything is firmly pressed against the side of the tube with no clearance.

Then it is time to go up .25” in diameter on a new tube. If you have a 2” now, go to a 2.25” diameter. For good quality at a reasonable price I would go to picturebrite.com.

Most cylinders start in the 9” length and that is what you should have. Same thing I just said, go to picturebrite.com for good quality and good price.

One thing though, I am suspicious your cylinder came with a rubber bulb pump and no quick disconnects. Does your cylinder have a quick disconnect female fitting screwed into the top?

Yes there is a quick disconnect at the top of the cylinder, however it is a hand pump with a needle guage. It still leaves a circle indention on the tip of my head, so I need to order a longer one. Thanks for the order info. :)