Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Newbie can't get a perfect seal -- is continually pumping the pump ok?

12

Daysdrag:

Some have found success with some kind of wrap or strap around their balls while pumping, to help keep their balls from being pulled into the pump. It could be something as simple as a strip of cloth.

What is your base girth, and what is your pump diameter? And what vacuum level are you pumping at? You could have a cylinder that is a bit too large for your base girth, or you could be pumping at a little too high vacuum. Keep in mind that you do not have to have just one static vacuum for the duration of your pumping. You can start out with very low vacuum, get a little base expansion, then gradually increase your vacuum level to your target during the course of your session.


For Lampwick, becoming hung like a donkey was the result of a total commitment.

Lastnight I had the most effective session yet. I took the advice to dip the cylinder in water, and do a 180 degree turn right, then left. I didn’t have any problems getting a good seal, pressure did leak once or twice, just slightly throughout the 10 minute session. I believe this was due to the position I would hold the cylinder in. No problems this time around.

Lampwick, I only took measurements of my girthiest part, which was the mid section. Measured out to be 4.7in. I am almost certain I was packing a little bit at the base lastnight, the tight seal allowed all shaft to engorge and no sack flab to interfere. Would you recommend just sticking to this size cylinder (1.75) if my expectations are to gain girth, and I’d take whatever increase in length I gain along with it.

Thanks

daysdrag

Question

I just got my LA Pump yesterday. My tube size is 2x9.

The problem I’m having or what I think is a problem is this: I’ve tied my balls down so they don’t get sucked up, but now it seems like my fat pad get sucked up more than my penis.

After about 5 min I can finally feel something in my penis.any suggestions

Originally Posted by puppetmaster
I just got my LA Pump yesterday. My tube size is 2x9.

The problem I’m having or what I think is a problem is this: I’ve tied my balls down so they don’t get sucked up, but now it seems like my fat pad get sucked up more than my penis.

After about 5 min I can finally feel something in my penis.any suggestions

Two questions. Did you buy the correct size cylinder? Are you entering the cylinder with an erection?


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

I’m 6x5, so I think I got the right size and no I don’t go in with a full erection. I’ve only been going in with a semi one.

I’ve been reading the board and some say going in soft is okay and some say go in erect. I guess with my suction problem, I need to go in erect.

P.S. It looks like I should’ve gotten the 1.75.dang. I’m have to make due

I used to have problems with my ball sack getting sucked up, my balls would ache after a session! I got one of these cock rings: http://www.lovehoney.co.uk/product.cfm?p=2589

Put it over your balls and tighten it a little; stops them getting sucked towards the cylinder - works perfectly! No more ball-ache after pumping!

Top
12

All times are GMT. The time now is 04:38 AM.