Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Loving my new Elliptical

◀ 12

Originally Posted by 32quarters
Some guys have been successful converting a conventional round cylinder into an elliptical by heating it and reforming the acrylic. However it could turn into an expensive project if one did not have the process set up perfectly.

If you happen to have a spare cylinder to practice on and didnt care if it became unusable if the procedure didnt work out would be a good way to experiment.

I have one leluv 2 inch cylinder spare…how to make it elliptical…. Please advise

Heat it up in an oven or with a heat gun until it is malleable. A small toaster oven could allow you to heat the base without heating (and deforming) the top. Use clamps and wood to squeeze the sides of the base to the elliptical shape you want, paying attention to the bottom so it will still seal against your pubis.

A good woodworker could make a mold in wood so that when heated you’d press the cylinder into the mold and have it in exactly the shape you want.

The first option requires a lot of manipulation of the heated cylinder and has greater risk of a non viable outcome.

The second option requires much preparatory work and less manipulation of the heated cylinder.

I’ve only read about this so am not an expert on the process.

Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7-7/8” BPEL; 7-3/8” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

I do also love LA PUMPS, they are awesome, dont hurt while under too much pressure due the round base.

ุ

Top
◀ 12

All times are GMT. The time now is 05:26 PM.