Custom Fit Your Cylinders, Cheap

Interesting. Thanks for sharing. So, the ridges don’t hurt when you get pumped up?

Barely even feel them. The ones on the 1/8” slicone ones were pretty bad, though.

The two bigger ones aren’t completely finished yet, so they look more harsh. I take sandpaper and bevel them down for comfort.

Hi… Wi-fi seal this one? How is it? Soft and wide opening?

It’s the one they sell in the LeLuv store on Amazon. The opening is about an inch wide, but it stretches enough to completely flatten out against the tube. Makes it easy to go in flaccid instead of taking the time to work up an erection. They hold up pretty well, too. Been using the same one since April and it’s still in good shape (the one in the picture is new), and they come in a 3-pack.

Thank you… They have many sleeve….can you share me exact one link. I bought one sleeve from leluv which is like little hard and cause me discomfort while pumping….please share the one you have…thanks

https://www.ama … /dp/B00QJE3IFA/

Thank for sharing pics of your rig and the link to the seal.

Could you also share where you purchased your tubes and entire pump set up? I’m coming up on 60 days pretty soon and I see myself moving into a hanging/pumping routine past 90-120.

I ordered all of it from the LeLuv store on amazon. I got the Maxi pump kit, an extra cylinder, and the seals. Because of the technique I use, I later ordered a quick-release valve and installed it just above the tube because I got tired of fiddling with the screw valve on the pump.

Shims were annoying to use. I made my own tubes with around 2 mm intervals. They feel grrreat!

They work great for me after finding the right material. But I am curious about how you made your own tubes in such small size jumps.

I ordered ready made acrylic tubes. If I recall correctly the sizes were (outside diam./outside diam.)
50/40
50/42
50/44
50/46
60/50
60/52
60/54
60/56
70/60
+10mm acrylic sheets

I cut a short 60/50 piece as cylinder base so the cylinder would not be too sharp. I used an router to round off the edges and hot clued everything together and used leluv female adapters. All the pieces were 2 meter tubes so all the materials cost quite a lot.

Man, that’s a lot of money. I think I’ll stick with my cheap-skate shims, lol. Why were the shims such a pain to deal with?

Did that, just a bit differently. Bought 20cm of a 2” PVC hose, cut it open and fit inside my cilinder. The wall of the pvc is about 1/8”.if anyone interested can send some photos.

Very impressive the difference, my unit expanded almost 1cm more than previously without the shim on the first day of use .

But I am packing it with the shin only about 50% in girth.

Yes please…give details with photos….pvc is transparent or not

Follow photos attached. Pretty straight forward.