Penimaster Pro Vacuum Suction After Wrapping Glans

Hello.

I’ve been reading on taping the glans to protect from blisters when you vacuum extenders such as the penimaster pro. My question is, how do you get the penimaster vacuum on the head of the penis after taping it? There is literally no grip I add any kind of tape to my glans. I tried both micro pore tape and micro foam tape and the penimaster suction ball now cannot grip my glans for a secure fit due to the tape getting in the way. What is the work around for this and how are you all able to accomplish this while using the penimaster pro extender with tape on the glans? Please help as I am new to all of this.

Thanks for any input!

Hi…if u tape the glans with micropore, do not use the diaghram on glans chamber. Put little lube on the micropore covered glans and pump in to the chamber. Hope u can do it. Also try to little wet the micropore little

Thanks for the feedback! I am a bit confused by “don’t use the diaphragm on glans chamber”. Do you mind elaborating on what you mean by that? This is the main thing that is holding me back from my PE goals so it would be awesome to find a solution!

Thanks!

I mean there is diaphram on the glans chamber. Remove it and attach the sluice to the glans chamber. I hope you understand. Come back to me if you still u did not get.

Thanks for your patience. I’m still not quite understanding how to do this. I must be an idiot lol. Which part is the diaphragm on the suction cup that needs to be removed? Is it the oval ring part that attaches to the suction chamber? If so, wouldn’t removing that part prevent the vacuum from working? Do you happen to have a picture of this assembly that you are referring to and is this how everyone accomplishes using the penimaster with tape on the glans?

Remove the oval ring which attach to the glans chamber and then u can see a diaphram on the glans chamber. then attach the oval ring back to the glans chamber. you are done

In the previous comment, you said attach the sluice to the chamber but here you said attach the oval ring back to the chamber. Can you confirm which one is correct?

Thanks

Can anyone else chime in? Help a newbie out

Last time I checked, their website has videos showing in details how use the device with parts labeled. Watch the videos and you’ll see what he talked about, basically you just exclude the diaphragm from the assembly.

But I’m not sure if not using the diaphragm would help you to avoid blisters entirely because it’s very likely there is air gap between your penis (even when fully wrapped) and the bulb, so vacuum suction can result in fluid collection at the penis tip, and eventually blisters. IMO, the diaphragm design is genius for this device because it acts as second skin to exert pressing force on over the entire glans to prevent blisters in such vacuum setup.

Thank you!

Once the penimaster is assembled without the diaphragm, how do I release the vacuum once sucked? If I twist the rotary valve to release the pressure when the diaphragm is off, nothing happens.

Thanks

Anyone?

Yes…it will not pull out glans same like diaphram on….after releasing the rotary valve, you have to slowly pull glans out of the chamber.

Hi bro please check your PM…thanka