Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Is it ok to double grip for girth?

Is it ok to double grip for girth?

One free PE site instructed a double “ok” grip for increasing girth. With the penis engorged 60-80%, grip the base of the penis with one hand cutting off blood flow. Then with the other hand “ok” grip the head of the penis at the glans but use the whole hand. The result is a pressure increase to the shaft of the penis between the two grips. I feel more pressure pump with this than I do the ULI method. (Just wanted to add that the ULI pumps harder with a BC muscle flex) Is this wrong, ok, or dangerous? Nothing hurts and I have been doing it for a week now. Doing PE exercises for almost 3 weeks now. My penis does feel more sensitive to pressure after and starts to fill almost immediately upon being released from my pants. Please comment.

This sounds similar to the Horse 440, where you grip tightly at the base with one hand and slide the other hand down over the head, except the one you’re describing squeezes the head without moving the hand over it, am I right. If I am, I do this quite often, just because it seems a good way to increase shaft girth. I fact I find it easier to do it with a cable clamp in place behind the balls so I get as far down the shaft as possible to minimise “baseball bat dick”.

I don’t know if I would have started that after just 3 weeks of PE though. I think I didn’t actually do anything except manual stretches and wet jelqs for about 2 months. But then everyone’s different, and as long as you’re not experiencing any pain or numbness with this then I guess you’re good to carry on with it. :)

But wait to see what one of the vets says, as they’ll probably have had more experience with girth work than me…

Good luck!


Start: 22 Mar 04: 6.5" BPEL x 4.6" EG & 6" head. As at: 1 Jan 05: 7.5" BPEL x 4.8-4.9" EG & 6.3" head.

Re-re-start!: 6 Feb 17: 6.9" BPEL x 4.9" EG & 5.5" head. As of: 23 Feb 17: 7.0" BPEL x 5.0" EG & 6.0" head.

Ideal: ASAP: 8+" BPEL x 5.5+" EG & 6.5+" head But will continue if the going is good!!

Thanks for replying Rifor. I am curious though, you mentioned a “cable clamp”? One of my concerns is that the double squeeze I am using might increase in the middle and I would like it throughout the shaft entire. As for the Horse 440, that sounds like the Uli in a way. This double grip actually focuses pressure between the hands as I squeeze the base of the shaft in one hand and the head in the other (gently though).

For me its easier to position a cable clamp further down my shaft than it is my hand. A cable clamp can even be put behind the balls, allowing more of you shaft to be between the cable clamp and your hand at the head. It also lets you keep a tighter grip for longer, because unlike our hands, cable clamps don’t get tired! (:


Start: 22 Mar 04: 6.5" BPEL x 4.6" EG & 6" head. As at: 1 Jan 05: 7.5" BPEL x 4.8-4.9" EG & 6.3" head.

Re-re-start!: 6 Feb 17: 6.9" BPEL x 4.9" EG & 5.5" head. As of: 23 Feb 17: 7.0" BPEL x 5.0" EG & 6.0" head.

Ideal: ASAP: 8+" BPEL x 5.5+" EG & 6.5+" head But will continue if the going is good!!

Rifor,
What is a “Cable Clamp?” Do you make it, buy it in the harware store (Home Depot). I can see the comedy now.
“Yes, hmmm. This ‘ere little device we use to grab onto a piece of rope to maintain a grip while mountain climbing. But in the privacy of your own home, you can clamp this around your shaft to stretch it out. I think Lorena Bobbit owned one of these.”

Sorry, sadistical humor…

Honestly, please correct me and give me the true details.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Girth RoutinesThunderSSPenis Enlargement5806-06-2022 09:04 AM
How to JelqThunderSSPenis Enlargement15211-27-2021 06:44 AM

All times are GMT. The time now is 08:20 PM.