Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Vacuum Pumping 101

For some reason water works for me. I simply submerge the tube in a measuring cup of warm water, slap a little water on the protuberance and done.

Hey guys,

Total newb in PE here

Just bought my LeLuv pump. Tried it out at 5 Hg the first run - no problem

I tried it again, but the base is thick, and it’s causing a lot of discomfort in my balls

Anyone ever experience this?

Welcome to Thunder’s knead_girth.

Will help if you provide your erect girth measurement and the diameter of the cylinder.


Start 6.8” x 4.7” (4.9" BEG)

Now 7.5” x 4.9” (5.1" BEG)

Regras do Fórum

Originally Posted by Useless
Welcome to Thunder’s knead_girth.

Will help if you provide your erect girth measurement and the diameter of the cylinder.

I’m using the 1.75” with this TPR seal: http://www.amazon.com/LeLuv-Replace…ailpage_o00_s00

I have an EG of 4”

Looks like the cylinder is too big. Are your testicles getting sucked inside the tube or just the skin?


Start 6.8” x 4.7” (4.9" BEG)

Now 7.5” x 4.9” (5.1" BEG)

Regras do Fórum

It feels extremely uncomfortable, because the spermatic cord gets pulled in.

So the cylinder might be a bit too big. I don’t have low hanging balls either, so that might be the issue?

Could be it. Wait up for more opinions about it.


Start 6.8” x 4.7” (4.9" BEG)

Now 7.5” x 4.9” (5.1" BEG)

Regras do Fórum

Stretch your scrotum out before you enter the tube and when you put the tube on, bone press it into your crotch as you begin to pump up. I think that should help.


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

When pumping, should I be 100% erect?

Thanks

I am having “doughnut” [a thick, fleshy ring beneath the head (glans), it started when I used hot water in my pulser. Is it safe? I am a newbee.

Originally Posted by knead_girth
When pumping, should I be 100% erect?

Thanks

Yes or as close to it as possible.


Started 7.75x5.75

Currently: 9.75bpX6.75eg My Picture Thread

Goal:10.0bpX7.25mseg Building a thicker unit, click by click, pump by pump, jelq by jelq!

When I started pumping, my EG was 4.4” and I found a 1.5” tube more than enough. However, Gprent’s suggestion should help. Also, hold the tube tight up against the bottom of your shaft as you posh it in against your fat pad.


Start 11/09 BPEL: 5.5", EG: 4.4"

Current. BPEL: 6:4", EG: 5.5"

Hi everyone, my routine consists of mostly pumping and aiming for length in the beginning. I was under the impression that pumping with a flaccid unit would work better for length. Is that the case or should it still be erect?

Great post! I use the bathmate and apparently I’m using it correctly but one thing concerns me, as I put more pressure my pubicbone or the skin over it hurts, is that normal?

I have been pumping on and off for a couple months now, a little more on lately, I’m finding it a bit addictive, I enjoy the pulling feel and the after hang. There wasn’t much difference in my routine tonight, however I after about 10 minutes at 5hg, I hover around 4-5, I pulled cylinder off to find a red cock which dissipated into a heap of red pin head marks. No pain or discomfort, I’ve just started using occasionally twice a day. I stopped there, some fire goat rolls and massage however I’m wondering if I should take time off, or reduce hg? The dots are starting to disappear already, being 1 hour ago. Another thing is I released the pressure quickly this afternoon, normally I reduce over a couple minutes, could this be the reason why?

Top

All times are GMT. The time now is 06:40 AM.