Small lumps on dick
I started pumping yesterday and suspect I over did it. Advice is requested, please. I never have been much good at following instructions.
I purchased a pump that is a bulb and has limits on the pressure you can apply to the cylinder. Yesterday, I filled the cylinder with warm water and pumped to the limit of the bulb. That meant my dick grew to its full erection length and then some (BPEL = 183 mm; I saw 186 mm on the cylinder graduations) and I had heaps more girth than I have ever seen. The cylinder is 2.25” diameter and I damn near seemed to fill it, but much of that probably was an optical illusion because of the water. I held it there for about 25 minutes (probably too long).
More than that, more and more blood seemed to enter my dick and it grew over the time, starting at about 178 mm and ending at 186 mm. That meant it displaced more water and the pressure fell. So, I pumped more as this happened to keep the pressure constant.
Just as an aside, I suspect I purchased the wrong cylinder because its length is only 20 cm (8”). But then my goal is 8 X 6, so maybe not.
The water was warm when I started and I had an infrared ray directed at the cylinder to keep it that way. There was no pain at all — only VERY, VERY pleasant feelings — and I did leak a fair bit of precum during the process. I had no pain afterwards all at either; however, my dick was a bit blue in colour and somewhat swollen, but less than after doing Ulis. And there was no donut like I get with Ulis. Most of the blue colour had disappeared after about an hour and all within 6 or 8 hours. All up, I thought, a very positive experience. I enjoyed it immensely.
The other thing I did wrong was to wank after an hour when the instructions with the pump said to wait for two hours. I know, I can be a bit of a dick sometimes.
This morning I note a couple of pimple sized lumps on my dick. If I squeeze these between my thumb and forefinger, they disappear, but return fairly rapidly. They are not red or sore in any way. I assume I overdid it yesterday, but seek advice from those more experienced in this please. Thanks.
Last edited by RickM : 02-26-2010 at .