Pumping produces permanent gains

I’m actually in good terms with the color of my penis. My color is 95% perfect actually, I actually like the color better then my normal color at the moment. I need to really clear up something: I don’t advocate high pressure pumping and in my book, high pressure is anything above 7 Hg. 7 Hg can be considered high, for me at least, if I do it for longer than 10 minutes. I actually really pump at 5 Hg most of the time more then likely considering that I don’t constantly stare at my gauge. I just pump to 7 Hg and release the connection to the tube a chill.

A lot of times when I reconnect the pump to the tube, the pressure drops down below 5 Hg. All I know is, I know what the fuck Im doing. I usually get the beginning of a donut after my longest sessions. I never pump to the point of donuts anymore, I never get bursted capillaries (red spots), (none that I can see at least), I always pump in short durations now which has been a key to my recent success to 6 eg. So I have had a recent gain, so I am doing something right at the moment; I think it may be the shorter sets and aiming for expansion rather then edema. I do still get edema though, it is completely unavoidable. I do agree with the vets that being patient, keeping the sets short and sweet, and lower pressures are best for the long run….I just may be an exception I guess because 7 Hg does not hurt my penis in anyway what so ever.
It may be because of the hot water and the warm ups I do before I pump and I do pump every day, so I am sure I am conditioned. Like I said before, when I pump to 7 Hg, my pump slowly leaks out some air from me yanking on the tube or if my pubes are too long, causing a bad seal. So I average at 5 Hg. I think water effects the pressure as well, meaning that when one uses water, the more pressure one can handle.

Go flyers..
But go.pumping with permanent gains. I start pumping today.

Tiger

Clubber what kind of pump do you have?

I did four 15 minute pumping sets everyday for three months and gained about 3/4 inch in length, but nothing in girth. I did no other form of PE during that time. I have been pumping on and off for about a year and have gained maybe 1/8 in girth. I have read about people gaining girth through pumping, but it doesn’t work for me.

Would one fo the pumping vets mind clearing up the difference between water pumping and air pumping?

Do you need to be submurged in water, i.e. in the bathtub, to water pump?

Is there a different set of equipment that is required for water pumping?

No, you just need to fill the cylinder with water. Step 1. put a small amount of water in the tube. Step 2. place dick in pump and pump up. Step 3. Make sure you don’t pump water through the tubing that leads from the cylinder to the pump w/ gage. The reason why you don’t fill the entire cylinder with water is because depending on how large your penis is, your penis will take up the vast majority of the cylinder leaving limited room for water.

What make of water pump do you use?

any good cylinder can be used for air and water pumping. I have been pumping for over nine months, so I feel comfortable replacing my Harbor Freight pump with a rubber ball pump (no gauge) when water pumping.

Hi Clubber, first of all, I congratulate you for your gains :) I have a question for you, if I have a 5.2 MSEG and 5.6 BG penis, what size of cilinder should I be using? the other day I went to the sex shop but the cilinder was at least 7.6” what size of cilynder would you recommend me?

Thanks man. That cleared up a lot.

So I take it that you have to have the cyliinder relatively vertical so that gravity keeps the water away from the tubing and pump? It seems like you would either need to lay on your back or at least have the tube pointing somewhat upward.

About how much water do you use? Just enough to submerge the penis once you reach maximum engorgement in the tube? I guess I am still confused as to how you keep the water from going into the tube.

Eventually the moisture will get your gauge no matter how careful you are.

Does that mean the gague will be destroyed? I use a harbor freight style pump to bleed the brakes on my dirtbikes and it seems to be just fine with getting a little brake fluid in it, but maybe it is a different type of pump than what is normally used for PE?

Same pump, but different liquid. Brake fluid doesn’t rust metal. I don’t recommend it, but you can always pump your penis in brake fluid.

Like ThunderSS mentioned the moisture seeps in. I use the MightyVac pump which is mostly plastic; it is a fabulous pump and I’m very happy with it. Here is a link:

Mityvac Vacuum Pump - Save on Mityvac Pumps at Harbor Freight!

This pump can handle the moisture much better then the classic pump handles which suck in comparison.

I use the cylinder from the Dr. Joel Kaplan pump, which I am still happy with but I would like one of these: Cylinders Tubes & Supply for Vacuum Pumpers & Penis Enlargement

I’ll post a pic of the cylinder I’ve been drooling over and the cylinder I currently use, which is 2.25 in diameter, which is made for dicks a little over 6 eg.

Any man over 5.3 eg can use a cylinder this size very comfortably. It is the 2.5 inch diameter that can cause problems.

I put enough water to submerge my penis which just fills 3 inches of the tube about. I detach the plastic hose from the cylinder once I’m pumped so I don’t have to worry about getting water in the pump. These cylinders are designed to hold in pressure.

Alot if questions that guys have will be answered once they start water pumping. It really is simple and easy to figure out.

^

I really want that glans cylinder. It is supposed to help prevent the donut. Has anyone used it yet? I also posted a pic of the same exact pump I use, the mighty-vac.