Pumping blister

Sorry, I cross-posted this thread. Just looking for an answer!

Well, I pumped at too high for too long, and I have a clear blister on my head! What to do?? I did a search & one response said not to pop, but I wanna get rid of this thing!

Don’t pop.

Don’t pump again until it is completely healed.

Be very careful not to overdo during the first session when you resume pumping. Make it a short session at minimal pressure and work your way up gradually.

When you do resume, consider condom pumping for ‘counterpressure’ to the vacuum.

In the past I have put a pin hole near the edge of the blister to drain it. Try not to let the skin come off too soon, or the raw skin underneath will sting like hell. It’s going to take a while to heal.

High pressure does not work well with pumping. Stick to lower pressures and no more than 1 hour total pumping time and 1 hour is pushing it.

Thanks for the reply. The thing was really getting in the way this morning, so I went ahead and relieved the pressure before I got in the shower. Boy it did not stng prior to popping, but once the water hit it, it stung like a mofo..

The pressure stuck up on me. I was just cruzin the web, looked down & I was up around 13 on the harbor freight pump. I usually pull the tube a few times before letting the pressure go, and that is when I think it happened.

I’ll let it heal. Thx