Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Pump Questions

Pump Questions

I am unable to post in the Pumper’s Forum so I am posting here hoping a moderator will move this post.

I ordered 2 cylinders from Lapdist. One being a 1.75” and the other a 2”. My concern is that after I do a hot wrap warm-up, the 1.75” cylinder doesn’t fit my base girth. Should I still use that tube to work length and the 2” to try and fill with girth?

Also, I have to say that Lapdist has one of the best customer service I have seen in a while. I heard they were slow on returning emails, but just give them a call and they definitely get you taken care of.

Any response will be appreciated.

Use the 2”.

I guess that was a big waste of money then. I mean, do people sell used cylinders? I used it once.

Like most other things, it depends on the price.

I mean what would be a reasonable price. I still have the invoice from lapdist and it was close to $100 after shipping.

I trust you are totally comfortable using the 2” tube? If not, you could always use the 1.75 for your first pump set, and then stage up to the 2.0 for your next pump set.

For an $80 cylinder? You might be able to get $40. You can negotiate by asking guys to send you a PM.

Originally Posted by gprent
I trust you are totally comfortable using the 2” tube? If not, you could always use the 1.75 for your first pump set, and then stage up to the 2.0 for your next pump set.

For an $80 cylinder? You might be able to get $40. You can negotiate by asking guys to send you a PM.

Is this ok, even though it doesn’t fit all the way down? I did notice I fit the 2” better when I used the 1.75” for the first time. I would like to get some good length gains that is why I went and bought the 1.75” and yes, I am comfortable using the 2. My main concern is that the 1.75 is to easily packed and I didn’t notice much length happening during the pump. Could this be a “fitting” issue?

As long as you use plenty of lube, you shouldn’t have any problem getting seated all the way down with your 1.75. Put lube on your entire shaft and the flange and first couple inches inside the tube.

Although with your existing girth, I can see you easily packing your 1.75” tube, a lot of new guys misinterpret this term. Packing is not just filling the bottom of the tube. It means your entire shaft from base to just under the head is completely filling the tube and up against the sides. It makes for a very squished look. :)

Thanks. I will just continue to use it then and hope for the best.

I also have the 1.75” & 2” cylinders. I am packing the 1.75” cylinder now, but I will continue to use it until I reach my desired length. Then I plan on using the 2” cylinder for added girth.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
pump maintenanceb1nzen48Penis Pumps804-10-2011 05:19 AM
J Meister's Late Night Pump RoutineJ MeisterPenis Pumps1907-05-2007 05:32 AM
Small pump at 4hg,donut at 5hg.....romeo1Penis Pumps1004-11-2005 09:52 AM
Cock and Ball Tube with pumpcyborgPenis Pumps903-12-2005 01:30 AM
new to pumping and various questionscrashdummiePenis Pumps203-10-2003 05:08 PM

All times are GMT. The time now is 10:01 AM.