Penis Pump Seal Break. Used 4 times only

I live in Asia. As title, my cheapo penis pump seal break.. I just used a few times ..

1.Did I did anything wrong to cause the break? How to prevent easy break?
2. Can I Use tape to seal the break?
3. There are no replacement seal for this product.. Can I buy vagina seal for it ?

Thanks, I m just a newbie .I only can post here, pls move to relevant section

Can I just directly pump without the penis seal?

Using skin as seal?

Yes, you can give that a try. It would help if you could give us a link showing what your cheapo pump looks like.

Here is the product link
http://www.365b … /goods-462.html

I have tried for 5 seconds.. It kinda work.. Just the skin made a budge.

Yes, it should work OK without that seal. If you can find an alternate seal, that would be OK too. Or better yet, maybe find a better pump to buy from a different web site.

It depends on your girth. That pump looks lie my first pump and it’s 2.5 inches, which might suck your nutsack in if you don’t have the girth.

Increase the vacuum very slowly if you go in without the seal! I doubt you could repair the damaged one, but you haven’t stated the extent of the damage either…

If you end up trying a new seal, make sure to use lube and don’t try to force your penis through the hole (like you would a vagina).

Instead, stick the tip of your glans into the hole until there’s a seal, then pump the handle and let it draw your penis into the cylinder. Do this and your seal will last much longer.

Thanks guys, you guys are helpful .

My country doesn’t sell reputable penis pump. If buy from ebay or amazon, it will cost me around $1000 (my country currency) and one meal only cost me $8_10.

You can’t use tape, but you can probably repair the seal if you want to try, here’s how:

Get some silicone sealant (make sure it’s 100% silicone) -

Get a bowl of warm water with a fair amount of washing up liquid/detergent mixed in

Squeeze out a blob of silicone sealant into the bowl

Play about with and squeeze the blob of silicone in the water - to mix more water with the blob of silicone.

The detergent stops the silicone sticking to you - and helps water permeate thru and set quicker.

Wait 10-15min - take the blob of silicone out of bowl of water.

You can then use the silicone blob to patch up ur seal - I have done this myself and it does work, but you have to play with the silicone first a few times to get the setting and feel of it right.

Since silicone sealant usually comes in 300ml/300g tubes - you’ll have plenty. So I would play about with a blob of it first in water - to get a feel for how it works and sets Before you fix up ur seal.

It takes around 2-8hrs for the silicone to set full (the water+washing up liquid/detergent speeds up the setting)

Do not use that stupid black elastic part. That prevent blood backflow. So i had discoloration because of this cheap pumps.

Now I am using German made frohle pumps. Any size you can get.
https://Www.amazon.de
Costs around 20 euro per tube.
My thickness is 5.5cm. I have three tubes. 5.5/6 and 8cm thickness.
Now using 5.5 for warmup then 6cm for traning.