Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

My PE Equipment and Day 1

My PE Equipment and Day 1

I finally got around to using a pump for my PE.

What I have in attached pic:

1. Cylinder (20 cm x 6cm)
2. Hand pump
3. Rubber seals (in small, medium and large)
4. A naughty egg (to get me going)
5. A heating pad
6. Water based lubricants

Pre pumping measurements

NBP: 4.7 inch yes I’m small :(
BP: 5.5 inch
Girth: 5 inch

I read the Vacuum Pumping 101 so I have this routine for now

> 5-10 minutes Warm up
> 10 minute session
> Cool down

This is my first week so hoping I get good results.

The pump isn’t that top notch but it was the best I could get for now, considering buying a bathmate but they haven’t replied yet if they deliver to my country.

Any advices/comments are welcome.

Attached Images
(52.1 KB, 143 views)

"Men are gifted with two heads, sadly they do not

have enough blood to run

both at the same time" by anonymous

Where is your gauge? I know that everyone goes on about them but trust me on this what you think the pressure is and what it actually is are very different. If you can source a brake bleeding kit with a hand pump this should work fine. In America they sell them very cheap in the UK its how much? bloody hell! Not sure on Euro zones.

I’m guessing that give minutes warm-up should be enough.

You might want to consider five minutes of vacuum, a 30 second break (light massage or a few light jelqs optional), and then resume your session.

Personally, I’m not in the school that says you have to go into the cylinder fully erect, or maintain a full erection during your session, so the ‘naughty egg’ would be optional on my list.

For Lampwick, becoming hung like a donkey was the result of a total commitment.

Lordaron: The package didn’t come with a gauge :( still browsing the forums on how to get one for my set

Thanks for the tip Lampwick.

"Men are gifted with two heads, sadly they do not

have enough blood to run

both at the same time" by anonymous

You do not need a gauge to pump but it is useful.
Here I will give you my method so you can still pump and keep yourself safe.

Steps to pump without a gauge:
1) Get a 100% erection
2) Place your erection in the tube without the hose attached and bone pressed.
3) With rather a grease pencil or a dry erase marker draw a line where your erections ends, holding the tube at a 90 degree angle from the line of sight.
4) Remove the tube and extend the line all the way around.
5) when you start your working pump session stop right when you reach this line and then check and pump over time.
6) Redue the above steps every two weeks.

A gauge is required. It is really to risky to not use one.


I’m curious. What is the “naughty egg” in your original photo used for?


Originally Posted by TuggerJoe

A gauge is required. It is really to risky to not use one.

The gauge is very important once you get serious and want to test your limits. In the meantime, follow The Great’s advice and be sure to stop at the first sign of discomfort and release the pressure until there is no discomfort. Also keep looking for a gauge or replace the bulb pump with a pump with a gauge. I don’t know what’s available in your area, but in the US they can be found for under $20. Keep the vacuum low and start conditioning your dick until you get one.


All times are GMT. The time now is 03:05 AM.