Hurtful Entrance

I received my first pump today. I went against GPent’s recommendations for the size and went for 2.75” wide entry because apparently my penis is really large for my girth. My testicles fortunately did not get sucked in, but another problem arose. The cylinder applies so much force against my body it gets to the bone and hurts a lot. It is tolerable only up to -3 HG. Do I just need to get used to it or should I find a way to enlarge the base to spread the force?

You shouldn’t be using anything larger than a 2.25” tube. I use a cylinder sleeve that is make of silicone. It makes the point of contact less concentrated. The size of the cylinder may not be helping. But since you disregarded gprents recommendation, I won’t say anything more on that.

Or similar.

I am just short of a 6 inch base girth and the 2.25 I just ordered Is still a little big for me. My testies get sucked up and squashed agaist the outside of the cylinder. I have to constantly readjust it so I can pump up to 5hg. But I could never go higher than that with this cylinder.

When I made my home made cylinder with a gravel cleaning tube I made a base out of molding clay you can buy from a craft store or Walmart. My homemade tube is 10x more comfortable than the cylinder I bought online. I bought some more clay and I am going to try and make a base for this one I just bought. They do sell silicone bases for the cylinders however I have no experience using those so I can’t really comment on that.

Since you bought such a huge cylinder, you could try to do full package pumping just to see if it is more comfortable that way.

I should specify the reason I chose a 2.75” is because I am 2.25” large with the veins, so a 2.25” cylinder was really not an option. I also checked for 2.5”, but could not find something that would be long enough, so I optedAny for this one.

I just ordered a silicon sleeve, and will try with the balls in tomorrow.

HardHarry, how do you make the base with clay? Do you need a whole clay-moulding set-up?

I’m nearly 7” in girth and I use a 2.25” cylinder and it works quite well. Not sure what you were thinking going with a 2.75”. Well like Gprent suggested you may be able to use it for full package pumping. Good luck!

So I received the sleeve and it works quite well. Although I did pump another time without it and there was no such pain either. The only problem is my penis really doesn’t look that big in a 10x8.6 cylinder.

I don’t think anybody’s would.