Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Heat = Quickest way to pack a tube.

The gift of heat is something I have never run away from. It has been of great use throughout my sessions.


05/12/2005 : BPEL: 6.1"x EG:5.5" Current as of : 24/12/2011 : BPEL 7.87" x EG: 6.3" Long term Goal 8.5"x 6.4"

" There is only one option success; for failure is the refusal to persist"

Does anyone have a preferred source of heat? I’ve used the neck warmer rice socks, but also have dabbles with the electric heating pads. I am debating getting one of those infrared lamps for keeping a constant warm temperature during workouts.

With hanging or manual stretching, with jelqing, clamping or pumping …..the heat is a necessary piece of puzzle that will bring gains. It’s a hassle sometimes but gotta use it. Use the heat to pack the tube.

Anyone ever try using a pump in or after a hot tub? My thoughts would be to soak before to warm up and then have consistent heat while pumping in the tub being surrounded by hot water.

This is my first post and relatively new to PE, doing newbie routine. I do have a pump on the way though.

if using an air pump, be cautious to keep water out of the pump. Use a longer hose or add a fluid reservoir in between pump and cylinder. The brake bleeder pump kits have a fluid reservoir included.


Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7.75” BPEL; 7.25” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

Originally Posted by squid7
Anyone ever try using a pump in or after a hot tub? My thoughts would be to soak before to warm up and then have consistent heat while pumping in the tub being surrounded by hot water.

This is my first post and relatively new to PE, doing newbie routine. I do have a pump on the way though.

I’ve pumped in the hot tub for years. Use it normally and then sit in the heat. The lube you choose should make a great seal with the vacuum.


Started 7.75x5.75

Currently: 9.75bpX6.75eg My Picture Thread

Goal:10.0bpX7.25mseg Building a thicker unit, click by click, pump by pump, jelq by jelq!

Heat,

Thank you greatly for this advise, I cannot believe the outcome, I tried it today with a heating pad I bought off Amazon and wrapped for an hour in the heat. I never packed my 2” tube yet like this, and it wasn’t goldfish after
I cannot believe it, after just 17 minutes I had about 3 inches already from base packed. At the hour mark, was almost 4.5 inches packed

Originally Posted by WantToGrow3
Heat,

Thank you greatly for this advise, I cannot believe the outcome, I tried it today with a heating pad I bought off Amazon and wrapped for an hour in the heat. I never packed my 2” tube yet like this, and it wasn’t goldfish after
I cannot believe it, after just 17 minutes I had about 3 inches already from base packed. At the hour mark, was almost 4.5 inches packed


WTG - dick pics are not allowed in public forums. If you want to post it, do so in your personal progress log and then link to it in this thread.


Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7.75” BPEL; 7.25” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

Originally Posted by 32quarters
WTG - dick pics are not allowed in public forums. If you want to post it, do so in your personal progress log and then link to it in this thread.

apologies, I was too happy, i’ll pay better attention forward going.

Yup, this works! Here’s how it works the best for me. Warm up my dick for a couple minutes, then stretch, front, up, down, left, right — 10-12 reps. Then repeat the warm up and at the same time, pre-heat your tube, by soaking it in hot (tap) water (about 110 degrees) for 3-5 minutes. Put my erect dick in the tube and wrap the tube with a rice sock. You have to re-heat the sock about every 15 minutes. I like to vary the vacuum from 3 to 6 (maybe 7) in hg.

Doing this, I can pack my 2 in tube to the ridge of my head in 15 minutes. I think, I’m going to find a wider tube.

I cycle this method with clamping and hanging.

Start 3/18 — 7.25 bpel x 5.5 mseg

Now — 8.25 x 6.25

Goal — 9 x 7

Originally Posted by Tofer

Yup, this works! Here’s how it works the best for me. Warm up my dick for a couple minutes, then stretch, front, up, down, left, right — 10-12 reps. Then repeat the warm up and at the same time, pre-heat your tube, by soaking it in hot (tap) water (about 110 degrees) for 3-5 minutes. Put my erect dick in the tube and wrap the tube with a rice sock. You have to re-heat the sock about every 15 minutes. I like to vary the vacuum from 3 to 6 (maybe 7) in hg.

Doing this, I can pack my 2 in tube to the ridge of my head in 15 minutes. I think, I’m going to find a wider tube.

I cycle this method with clamping and hanging.

Start 3/18 — 7.25 bpel x 5.5 mseg

Now — 8.25 x 6.25

Goal — 9 x 7

Why not buy a electric heatng pad? Much easier to preheat and to heat during pumping. They don’t cost much.


190416 Bpel 16,5 Bpfsl 16,5 Meg 14,2 Beg 15,0

210312 Bpel 19 Bpfsl 19,6 Meg 14,5 Beg 15,3

___Gain Bpel +2,5 Bpfsl +3,1 Meg +0,3 Beg +0,3

Originally Posted by Tofer
Yup, this works! Here’s how it works the best for me. Warm up my dick for a couple minutes, then stretch, front, up, down, left, right — 10-12 reps. Then repeat the warm up and at the same time, pre-heat your tube, by soaking it in hot (tap) water (about 110 degrees) for 3-5 minutes. Put my erect dick in the tube and wrap the tube with a rice sock. You have to re-heat the sock about every 15 minutes. I like to vary the vacuum from 3 to 6 (maybe 7) in hg.
Doing this, I can pack my 2 in tube to the ridge of my head in 15 minutes. I think, I’m going to find a wider tube.
I cycle this method with clamping and hanging.
Start 3/18 — 7.25 bpel x 5.5 mseg
Now — 8.25 x 6.25
Goal — 9 x 7

Great Gains. Congratulations!!!


Starting (07/15/20): BPEL 6.5” BPFSL 6.5” MSEG 4.75” BEG 4.75” BPFL 4.5”

Current (10/27/20): BPEL 7.0” BPFSL 7.5” MSEG 5.0”+ BEG 5.25” BPFL 5.25-5.75”

Goal: BPEL 7.5” MSEG 5.5” BEG 6.0” BPFL 6.5”

Originally Posted by Tofer
Put my erect dick in the tube and wrap the tube with a rice sock. You have to re-heat the sock about every 15 minutes.
Doing this, I can pack my 2 in tube to the ridge of my head in 15 minutes. I think, I’m going to find a wider tube.

A reheat-able microwavable heating pad stay warm for a bit longer I find. Low cost investment w/a nice return.

Originally Posted by Tofer
Doing this, I can pack my 2 in tube to the ridge of my head in 15 minutes. I think, I’m going to find a wider tube.

Can definitely tell the heat is working when you release the pressure valve and can still feel pressure as you slide out of the tube because of how packed it is.


"Eat Beaver - Save Trees - Simple right?"

I take the cover off the heating pad and put the heating plastic part directly on the tube. Then lay the cover over the heating part to insulate your hand from the hot plastic and you can get way more heat by putting the heating part directly on the tube this way, even at lower settings.

Ok. I’ll try the heating pad and let you know if it’s an improvement in a few weeks. Thanks.

Top

All times are GMT. The time now is 11:26 PM.