Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

First time pumping...

12

First time pumping...

Well, not really pumping per se. I didn’t buy a pump. Ok, here’s the story.

I’ve been intrigued with pumping since getting into PE a couple of months ago. So a couple of days ago I bought a gravel cleaner tube. I figured it’d be a cheap alternative to test the waters. Unfortunately, the one I bought was way too small (1.65” outside diameter). I couldn’t even get my flaccid penis in it more than an inch after a lot of effort. But I did notice the pumping effect when I sucked the air out via the provided tube. So that got me thinking…I wonder if they make a 2” diameter one. Well, they do, so like a couple of others (hence, where I got the idea) I went and got one today. Just got done with my first session and I’m happy with it and will be adding this to my routine as well. I’ll be starting with three 5 minute session between sets of dry jelqs. The only thing I need to add to it is something like an o-ring on the bottom to aid in comfort and that should be easy to come by. I think I will stick with this for a while to see how it goes as an addition to my current routine before purchasing a more expensive unit.

Total price: $8.00
Where: PetSmart
What: TOPFIN Large Gravel Vacuum (10”x2” outside) (9 1/4” x 1 7/8” inside)

I did research by looking through posts here before trying it. Do any of you experienced pumpers see anything wrong with the length of time or anything else (besides the obvious benefit of actually having a gauge)

Thanks


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

averageguy72,

I think for initial experimental purposes with pumping, your home set up and 3 x 5 minutes sets are okay. You can decide later if you want to invest more into a professional cylinder, gauge, etc. I started out initially with my own homemade cylinder and locally purchased MityVac pump/gauge before moving on to better cylinders, which made a huge difference in my pumping results.

Peforeal

Thanks, peforeal


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

If you are going to spend the time pumping, you might as well do it right. I made my mistakes by slowly working up the quality line of cheap pumps to moderate prices pumps. The ones with the rubber gasket at the base of the tube and squeeze ball for a vac device or plastic bicycle pump like device. The pumps did not work well and wore out quickly.

I would have saved money in the long run, if I had just gone out and bought the high quality pump I ended up with in the first place. Go to:
Penis Enlargement Pumps, Breast Enlargement Pumps, & Vaginal Pumps| LA Pump and check out their deluxe pump package for $140. Yes, seems expensive, but in the long run you save. This is a quality system and it does not wear out. The pump has a gauge, so you are in complete control.

Check it out.


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

Thanks gprent, but I didn’t plan on going through a bunch of pumps before I bought a good one. I just wanted to try this for the rest of the month a then worry about buying one. The $140 isn’t bad, considering how they’re made. I was going to buy one from there anyway if this panned out for me through the rest of this month.

Thanks for the advice though.


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

Hi averageguy72

I bought a pump from ebay for a good price and it has lasted and works great for me.

This last week I have been using a heating pad wrapped around the tube. I have been able to pack the tub in half the time that it used to take me. I spend less time in the tube. I’m packing it without my penis looking all bloated and crazy.


What are you gonna do? Sic your dogs on me? Or your bees? Or dogs with bees in their mouth so when they bark they shoot bees at me? I think Mr. Smithers picked me for my motivational skills. Everyone always says they have to work twice as hard when Im around! Its not easy to juggle a pregnant wife and a troubled child, but somehow I managed to squeeze in 8 hours of TV a day. Getting out of jury duty is easy. The trick is to say youre prejudiced against all races. - Homer Simpson.

Average, I have 5 tips for making the Deluxe pump package, if purchased, just a little more deluxe.

To make the system completely leak proof, in addition to the O ring that comes supplied for the pressure fitting on the top of the tube, wrap the threads of this fitting with plumbers Teflon tape, before screwing it in.

As a lube for sealing the tube to your cock, I would recommend KY jelly or the equivalent cheaper water based lubes from Target or Walmart. These water based lubes provide a perfect airtight seal and clean up is so much easier than using an oil base lube.

For comfort, I would preheat my tube in the oven at a setting of say 150 degrees. You can put the tube with the pressure fitting in the oven at this temp with no problem.

Preheat your KY or equivalent jelly in the micro wave for 10-15 seconds. Just tap a little air pocket at the nozzle so the jelly doesn’t burp out when you open it.

While pumping, I wrapped the tube in an electric heat pad. This aids in expansion in the tube, makes it very comfortable, and eliminates condensation from forming. Bought my heating pad at Target for $15, made by Kaz, 12x15 inch pad, with 4 heat settings. The model number is HP710.


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

Average,

How do you like pumping so far?


One foot down...one to go

Wow! Lots of good advice!

I’ve been wrapping the tube with a heating pad. The only problem, so far, has been the comfort of the tube base (which is understandable given what it is and the fact that I haven’t had the time to go look for anything to aid that).

So far so good. Nothing spectacular, but I didn’t expect pumping to make my unit king-sized overnight. I’m doing what’s comfortable to me, pumping until slight discomfort and not more. Would be able to do more with a decent tube, which I intend on purchasing at the end of the month.

The good news is that I pack (maybe not at tightly as some of you) about 1/4 of the tube by the second or final 5 minute session.

One thing that concerns me is the few threads concerning LA Pump not returning emails. Is this still the case? Or does anyone know? I guess I could just test for myself. If this is becoming the norm for them, then I will be looking elsewhere when I purchase a better setup. And another question, I’ve seen pictures of people (obviously or it seems obvious to me) over pumping. I don’t want my dick to look like these photos, they look deformed (full of fluid…etc). While I understand why longer sessions will result in some build up, this isn’t the norm is it?

After this week of three 5 minute session, I plan on going to two 10 minute session and incrementing like that. Does the sound reasonable?

Thanks for all the tips! I appreciate it.


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

LA Pump gets busy; and the owner likes to take breaks. They will catch up with you.

BTW, the old site address still works:

https://www.cockpump.com

Have fun. Don’t overdo.


_______________

avocet8

Thanks, avocet. I went ahead and ordered from them (i.e. I like what is happening with the budget setup and plan on continuing with pumping as an addition to my routine). We’ll see how it turns out.


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

average, sounds like you already have a nice one on the way; but I’ll tell you what I did to make my gravel tube more comfortable — I rounded the bottom with electrical tape in multiple overlapping layers (so that it was half stuck to the tube and half not, sticky side in ((picture the tape wrapped like a ring around the bottom with half of the sticky surface exposed))), then took a pair of scissors, cut the tape into ~1cm increments and folded the increments in to stick on the inside of the tube; this formed a “tape ring” around the base that added some comfort.

Welp...

Ordered the pump last night and it’s already shipped. And they responded to an email question I sent as well.

Seems like LA Pump has good service to me!

Looking forward to having a better, more comfortable tube, and a guage.


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

BTW, SuperSizeMe, thanks for the tip. I hadn’t thought of that. I will try that until the new setup gets here.


------------------------- Started: 7" BPEL x 4.75" EG (September 2003) 1st year: 7.5" BPEL x 5.5" EG (September 2004) 2nd year: 7 5/8" BPEL x 5.75" EG (September 2005) Goal: 8" BPEL x 7" EG

I know this is probably a mute point since you ordered another tube, but another thing you can do with the gravel tube is heat it with a propane torch or other heating source gradually bend it outward (I used a pliers) to create a smooth flange. I did that & it’s extremely comfortable.


:boogie:

Top
12
Similar Threads 
ThreadStarterForumRepliesLast Post
PumpingsupersizeitPenis Pumps610-09-2020 10:36 PM
Pumping first timejroger21Penis Pumps202-26-2011 04:15 PM
Do you guys regret spending all that time on pumping and why?glanzinoPenis Pumps3606-05-2008 09:25 AM
part time pumpingjspacePenis Pumps210-24-2003 01:56 PM

All times are GMT. The time now is 11:31 PM.