Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Dropped my cylinder, chipped it, suggestions?

Dropped my cylinder, chipped it, suggestions?

So as I was taking my cylinder out of my bag the other night I unfortunately dropped it. I almost shed a tear because I am finally gaining consistently. It was a sad moment.

It got chipped at the end where it flares. I tried pumping with it and I can get a seal and pump fine but it digs into my skin and cuts me because it isn’t smooth anymore. Any suggestions on how to smooth it out or prevent the skin digging? It’s plastic.


In search of a perfect body, penis, and girl.

The search NO longer continues. :)

Take a lighter and hold the flame over the chip until the sharp edge melts over smooth. Also when pumping turn the tube so the chipped place is on top, dorsal side of the shaft there is less skin to get pinched in the crack. Or PumpToys sells a silicone ring that fits right over the flange.

Keep on Pumping


2003: 6X5 2010: 7X7

No Nukes

Thanks!


In search of a perfect body, penis, and girl.

The search NO longer continues. :)

If the flame hasn’t hit the tube yet, you might also want to consider filling the chip with clear epoxy and then sanding it smooth.


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

If its a small chip, Just sand it out with sandpaper

Damn. Should of been more patient. But I think if I sand the burnt part then go over with epoxy then sand it again it will be like new. Any suggestions for shaping the epoxy to get it to match the original flare shape?


In search of a perfect body, penis, and girl.

The search NO longer continues. :)

Just use fine sandpaper and wrap it around a small sanding block.


The primary goal of PE should be to make your penis as healthy as possible in both form and function. If you do that, increased size will follow.

Just sand the flare a slight bit shorter around the circumference of the cylinder until the chip is gone!

Duct tape

It is a huge chip though. I sanded it and it works okay but hurts a little. I’m going to get epoxy today and try to recreate the flare.


In search of a perfect body, penis, and girl.

The search NO longer continues. :)


Last edited by Thick Cock : 12-21-2009 at . Reason: sp

Get a rubber flange.

I thought all pumps came with them.


Current Stats: 6.9BPEL/6.4NBPEL 5.5MEG.

Current Goal: 7BPEL/6.5NBPEL 5.75MEG.

Yeah, what mr. whiskers said:

SLEEVE MASTER
http://www.bostonpump.com/index.asp…ATS&Category=24

Universal Silicone Replacement Donut Sleeve For Penis Pumps
http://www.amazon.com/y2Male-Person…ef=pd_sim_hpc_3

Have seen them on ebay too.

You might be able to find one in a dirty book store.


Last edited by sta-kool : 12-21-2009 at .
Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Homemade pump: more user friendly with innertubesJosh 14-11Penis Pumps1107-10-2014 12:21 PM
Where to buy pussy pump? And is LA Pump still around?venicejayPenis Pumps1207-18-2011 09:39 PM
Dr. Kaplan's hand pumpjallenPenis Pumps807-13-2008 09:41 AM
Why not just pump and stretchskitola11Penis Enlargement Basics105-21-2005 06:51 PM
Starter pump?swisslunaticPenis Pumps208-17-2003 10:32 AM

All times are GMT. The time now is 04:49 PM.