2 questions on pumping

I understand the reason for lubricant at the base to get a good seal,but what is the reason for lubricant on the shaft?

Also,if im doing newbie routine,what do you guys recommend ?pumping right after jelqing when im still lubed up?taking a break after?

As your pumping routine progresses, it is likely your shaft will start expanding enough to contact the sides of the tube and eventually pack it. You need the lube on your shaft to make sure you don’t get stuck.

An excellent pump routine is to do 2 and eventually 3 sets of pump followed by jelq. So you might start out with 10 minutes pump, 5 minutes jelq, 10 minutes pump, 5 minutes jelq. As a newbie you should do this using light to moderate force. I would use 3”hg pump pressure and a moderate jelq force to avoid damage such as red spots or worse.

As you gain experience, keep the pump pressure the same, but increase the pump set time to 15 minutes and work up to 3 sets.

gprent,thanks…i figured that was the reason.So its mainly important once i start”filling out ” my cylinder?

What about stretching?do u recommend still doing that BEFORE pumping?

I’m new to P.E. How much do penis pumps cost and is it worth the investment?

Lube is important even before you start ‘filling out’ your cylinder. You want your penis to slide easily within the cylinder as you expand during the session.

I think stretching is not a bad idea before pumping as a warm-up. A little light jelqing before pumping is not bad either. If you’re doing the Newbie Routine and you’ve stretched and jelqed, and you are lubed up, that’s not a bad time at all for a little light pumping. Just be careful not to overdo.

Reading Vacuum Pumping 101 would get you off to a good start on this topic.