Hello all. While this may be more of a general hanging question I figured it was more specific to the Wench than to a Bib. So my problem is that the actual wench slides up from where it initially lies. (Approximately 1 inch from the head.) The top end of it, basically a good half to full inch usually slides up the head and causes half the head of the penis to puff out from the Wench laying above it. Basically the head stops the hanger from sliding up anymore.
And I am not sure if it is a matter of tightness, I already strain a great deal to get three clicks with the clamps. And when I take them off, the top half of the penis is cooler than the bottom like the circulation is getting cut off. So I am worried about there being some damage to the head above where the wench cuts off and due to the fact that there is some degree of head pressure no matter how I seem to differ the wrapping job and cable clamp tightness.
I am wondering if I should just trim the actual strap that slides up over the head but I still seem to have some problem with head pressure. (Not usually painful but it is a uncomfortable towards the end of a 20 min hang.) As for the weight I started the first month with 5lbs, and am now in the second month with 7 doing 3 sets at 20 mins each.
Sorry if this is a lot of information. I will try to clarify anything that does not make sense. I appreciate any help that anyone can give. Have a good day.