vachanger

can someone tell me how to use this thing idk how to put it on correctly or if i should wrap before and monkey bar doesnt have instructions for it any where help please!!

Here is the email I got from Monkeybar. Hope it helps…

Hi, unfortunately we don’t have a detailed instruction. The device is in experimental phase and we are now just getting it ready to release it as a production model. This is a new product, so we like to test with many users as possible to make it its acceptable for release (most users are experienced PE’ers).

With that, if you look at VacExtender, the concept is same - roll the sleeve over the cylinder, apply the head into cylinder and unfold the sleeve over the shaft. The only difference between this and VacExtender is that you now have a control on how to remove the air. There are 2 ways, via side air release hole or via vacuum fitting on top of the cylinder.

Once sleeve is applied, you suck the air with your mouth using supplied tube. After air is sucked, while still holding the tubing in the mouth, you fold the tube few times and wrap the tubing with remaining tubing. Its really simple and you may need to experiment a bit to find how you like to do things but concept is easy.

One more thing - there’s going to be a sleeve change in about a week or so. The sleeve will actually go away and new and easier sheath is coming out. Another thing is that there will be a pinch clamp that goes on the line so you don’t have to fold/tie routine. Other than these two items, nothing is different. At that point, it will be in production and I’ll be providing more detail instruction on the website.

Here’s the info page for Vachanger - Autoextender Penis Enlargement Device

If you have any question, feel free to write back and I could help you.

Cool but i can’t open that link (it gives me 404 Not Found error).