Solution for twisting
Since I started hanging I’ve kept making new hangers trying to improve on the previous design. I don’t keep count but I probably made 10 to 15 different versions and most were better than their predecessors. I’ve been very pleased with my latest versions but there has been one problem I was never able to find a solution for and that was twisting. It has been hunting me for a long time but today I think I found the answer :)
This is what usually happens, I start out straight with tightening and when I’m half way my glans gradually starts twisting clockwise or anti-clockwise. Occasionally the twisting is minimal and I ignore it but often enough there’s too much twisting. When that happens I open my hanger and start over. (If I don’t I risk putting too much pressure on top of my penis, where the nerves are located, during hanging.) The second attempt I usually try to anticipate the twisting with my starting position, start tightening and then either launch a countdown timer or start over again till I get it right or get fed up.
Today I noticed that instead of starting over I can rotate the hanger in the opposite direction I want my glans to rotate back to and pull. Depending on how tight the hanger already was this worked with 90, 180, 270 degrees and when my hanger was already very tight I had to rotate my hanger 360 degrees and pull till it worked. Loosening the hanger will also help not having to rotate the hanger that much because 360 degrees looks a bit scary but I was curious ;)
I think this simple solution will work for all hangers based on Hubbard’s AFB hanger and possibly other clamp style hangers as well like the BIB.