Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Homemade Hanger Models and Instructions

So for my hanger (see a couple posts higher) it is also bad if I tighten the screws so hard that the circulation is stopped? Because I actually do. And I thought everybody does, thats why we should take breaks. So you don’t think my hanger is a good idea then? Thanks

If you look at the bib hangers or the captains wench you will see that they have constructed it in such a way that the clamping pressure is placed on the sides of the penis. This is to keep pressure off of the nerve bundles behind the glans. If these bundles get too much pressure placed on them you will begin to experience prolonged numbness in your penis. This will give temporary ED. It will go a way but can last for a week or two. I would try and place the same rubber skid pads that are placed in the wench in yours on the sides. Your hanger has been used before by others and with a few easy mods can make a great hanger.

I have a question. I built my hanger now and I can’t find a comfortable sitting/standing situation with weights on. I mostly do it in front of the tv and I prefer to lie down. So I mostly just take a string and put it around my foot and stretch with my foot. I know, the disadvantage is, that I don’t have the same pressure all the time. But in general about gaining length compared to the weight method do you think its a big difference?

The string is an interesting idea, but you have Little control over force.

And don’t ever clamp your dick horizontally, that could cause irreversible damage.


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

What do you mean by “and don’t ever clamp your dick horizontally” ? I don’t understand it. About the control of force: one set that I do I can control very well with having the same force during the set. I just keep the same sitting position and the same foot position. But when I start a new set etc. I surely won’t have good control, also since my penis feels different after one set and it’s hard to tell if I have the same force again.

Originally Posted by dangerdanger
What do you mean by “and don’t ever clamp your dick horizontally” ?


Correct me if I’m wrong (I’m not a hanger).

Some guys use clamps that work more like a vise with two flat sticks squeezing together. When using that method it is important to apply the clamp in a way that squeezes the sides of the penis together, not the top and bottom.

The image you supplied of your clamp is round so it should apply pressure equally from all directions but it is probably a good idea to apply it in the same way so any extra pressure is applied to the sides.


Keep an open mind and a closed wallet... unless it\'s open to making a donation!

Ok. Now I understand. I take my clamp with the two half shells being left and right instead of on top and bottom. So I don’t squeeze the top and bottom so much. But still to be honest I have a little less EQ. My EQ was probably one of the best you could imagine. Always ready and I was able to hold up to 10 pounds on the tip of my penis without him going down. But now, I feel he is not so hard anymore, which doesn’t really bother me since I felt he was too hard anyway.

Originally Posted by cantlook
Correct me if I’m wrong (I’m not a hanger).

Some guys use clamps that work more like a vise with two flat sticks squeezing together. When using that method it is important to apply the clamp in a way that squeezes the sides of the penis together, not the top and bottom.

The image you supplied of your clamp is round so it should apply pressure equally from all directions but it is probably a good idea to apply it in the same way so any extra pressure is applied to the sides.

This is exactly what I was trying to say in my post a few posts above, you explained it so much better.

Originally Posted by dangerdanger
Ok. Now I understand. I take my clamp with the two half shells being left and right instead of on top and bottom. So I don’t squeeze the top and bottom so much. But still to be honest I have a little less EQ. My EQ was probably one of the best you could imagine. Always ready and I was able to hold up to 10 pounds on the tip of my penis without him going down. But now, I feel he is not so hard anymore, which doesn’t really bother me since I felt he was too hard anyway.

A drop in EQ is normal, especially when you move up in weight. You should feel normal in a few days as you adjust to the new weight. If your EQ gets worse or doesn’t return to normal this would be an indication of moving up to fast in weight. Once you are used to the weight or conditioned for it you should still experience a refractory period of a few hours. If you hang in the mornings but your EQ is suffering at night you should either back the weight down slightly or consider how many sets you are doing. Sounds like you are on the right path.

Hey bigee. Thanks for the advice. Well.. I definitely would prefer hanging with weights then my string around my foot. Surely I would have more control and I could better adjust to changes with my penis. But it is simply so much more comfortable tu just lay down and footstretch. Well.I’ll do it for a month or so and then we’ll see.

Originally Posted by dangerdanger
Hey bigee. Thanks for the advice. Well.. I definitely would prefer hanging with weights then my string around my foot. Surely I would have more control and I could better adjust to changes with my penis. But it is simply so much more comfortable tu just lay down and footstretch. Well.I’ll do it for a month or so and then we’ll see.

Have you tried using weights and laying down, that is how true BTC angle are performed. It is really hard to get a constant tension with a rope or a string. The use of weights will give you a controlled progression with the intensity of your hanging sessions and this is very important. It is hard to track your progress and results without an exact form of stress. If it is all you have then it will have to do but there are many ways to create weight even if all you have to start out with is a milk jug water can be weighed by the ounce.

Sock cloth Hanger

Thank you for your response, Bigee, and I must admit that it is not the safest option for hanging. Also, I have not used this hanger with more than 3 pounds. Beyond this weight, the knot would probably need to be unreasonably tight and unsafe. From using it, it seems to permit 15 to 20 minute hanging sessions without injury or discomfort. I am sure there is some restriction of circulation, but I think that one must develop a feel for it, when it comes to knowing how tight to apply the device. This is was only proposed an option and by no means is a revolutionary design. As I increase my hang weight I will probably opt for a more sophisticated hanger design.

Originally Posted by SpeedDial
I’ve been a lurker here for a while. I started out using the Captain’s Wench for several months for ADS. After minimal results I decided to try hanging.

I used a swim cap hanger for a few months and had some success (about 3/4 of an inch) but at heavier weight (10lbs) found that the swim cap hanger put too much pressure on the tip of the glans causing bruising and/or blistering leading to callousing when I was willing to endure it.

I then decided to give the BIB hanger a shot. I tried that for a few months and could never quite figure out how to hang without much discomfort. After playing around with toe in and toe outs etc, I found the whole “gripping the internals” thing too difficult to figure out but I did gain about a 1/4 inch. I was experiencing some numbness as well so I finally decided to take a break from the BIB. Fortunately the numbness went away after a few weeks.

In the meantime I was thinking about how to get more of a swim cap approach without the swim cap and the pressure on the tip of the glans. Maybe what I have come up some might consider more of a noose style. In any case it was inspired by my experience with the swim cap and the captain’s wench. In fact I reused the nylon strapping I had used for my wench and some of the unused gripper pads. The entire hanger is made of nylon straps, gripper pads and Goop. Pretty simple design. The gripper pads are cut/shaped to fit up against the glans. The gripper pads are secured to the nylon with Goop. Velcro is secured to nylon using Goop. I use a wrap and secure the hanger with a theraband strap (wrapping around 3 times) that is an inch wide and about 9 or 10 inches long secured with a bit of tape at the end. When I run out of Theraband I will probably just get a swim cap and cut that up for straps. I could probably go a bit less on the wide part, maybe 3/4 of an inch but this was already cut to that width for use as wrapping with the BIB so I am just reusing it. Tension on the theraband when wrapping across the “gap” on the hanger provides tension to tighten the hanger. I have been working with this hanger since early December and still using fairly light weights. I started at 5 and am doing about 7 lbs right now. I usually do 20 minute sets. And hoping when I get up to 10 - 12 lbs range that I will start to see some further gains. I’m not sure how well it will hold at that weight though. I figure if I need to I could try a clamp to provide a bit more grip.

Update on my home made hanger. I’ve found that after re gluing a few times (maybe 3 or 4), I have not had to re glue now for several weeks. I still suspect this need to re glue was due to the adhesive on the gripper pads. I suspect that this has finally broken down and that is why I have not needed to re glue for some time now. I am now up to about 12 lbs with my hanger. I am doing my third 20 minute set 20 set of the morning as I type. I have had no issues with numbness with my hanger and minimal discomfort. Been hanging BTC since I started to use this. I was concerned about the grip at higher weights. A few weeks ago I started to use a double wrap. The first layer is a cloth from some old under garments. The second layer is a strap made from a swim cap (initially I tried theraband for this but the result was not satisfactory - too thick). This second layer adds a bit more protection and really helps with the grip of the hanger as well. I have never experienced a slip yet. I am still securing the hanger with a strap made of theraband wrapped around 3 times and secured with a bit of tape for the set.

20 seconds to get the hanger off. Usually a minute to a min and a half to get the hanger on.

I use a handi-clamp modified with grip tape and a weigh scale hook .

My wrap is 4” cling wrap bound with electrical tape.

The wrap takes about a minute to do and the clamp takes seconds to attach and to remove.

Occasionally I have to re-wrap in later sets as the wrap is forced down.

And plenty of heat.


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

Hanger I made

So my hanger one I’ve seen on here not try it yet need some advice first hope this were post if not sorry. Put some picture of it on to. So I have been using pro extender for few months and now thinking of do hour on hanging and 3 hour with extender. The problem is wrapping and how much weight to start off with do I pull skin back when wrap or not and is bandage ok to use to wrap thanks hope use can help me with this.

2013-02-26 17.05.50.webp
(31.5 KB, 253 views)
2013-02-26 17.05.13.webp
(31.8 KB, 281 views)
2013-02-26 17.05.04.webp
(31.4 KB, 169 views)
2013-02-26 17.04.50.webp
(23.7 KB, 166 views)
Top

All times are GMT. The time now is 07:33 AM.