Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Hanging w/ a Vacuum Tube as the "grip"

Hanging w/ a Vacuum Tube as the "grip"

Has anyone used a close fitting vacuum pump tube as the “contact” point on the penis then attached or rigged weights to it for stretching? Any ideas on why not to, difficulties with this, etc? I imagine that pulling the pump-tube may increase pressure on the glans which can become problematic but other than that I’m up for hearing any ideas. I’m thinking doing this on low pressure (~5 psi/atm or less) is best for that one reason. I figure I can glue some brackets on the side of the tube to connect string/cord to and then pass the string/cord over a fulcrum point with the weights attached on the end. With that I could control weight application by simply moving away to raise it.

Never tried it, but certainly thought about it. I’d make some kind of anchor at the top of the tube, and use a bungee cord as the weight.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.3" x 4.8" volume 13.4 ci

The effect will be more or less the same as pumping at higher pressure though. It will relieve some force from the pelvic bone. And could be good for maintaining an erection in the tube by reducing the force required to milk the tube. Also raises the possibility of getting to pressures beyond atmospheric, but maintaining the grip on the penis as the tube moves up the shaft may be difficult.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.3" x 4.8" volume 13.4 ci

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Vacuum Hanging and comfortXristoPenis Hangers304-22-2013 12:41 AM
Breaks between vacuum hanging setsUpTo7Penis Hangers2109-02-2010 07:17 PM
Hanging Guidelines / Personal & Average Maximum Gain-rate (PMGR & AMGR)Mr. FPenis Hangers1208-03-2010 05:50 AM
Vacuum hanging confusionMr. NinePenis Hangers6406-06-2006 03:19 AM
Hanging using a head enlargement vacuum pump ???danolsPenis Hangers1901-02-2005 02:45 PM

All times are GMT. The time now is 02:10 AM.