Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Finally hung some weight. Have some questions

Finally hung some weight. Have some questions

I made a wrench many months ago but could never attach it to my dick so that it doesnt roll off my foreskin and fall off. But last night i figured out a way, and I test hung 2.5kgs for a couple of minutes. So i have a couple of questions based on what i experienced last night. Firstly, with the weight attached, the wrench will slide to just below my head, and when I touched my head it felt like it was going to explode. It was like I could pop it with a pin and it will burst like a balloon. Is this experienced by all hangers? Also, my skin over the top part of my base seemed to take most of the stretch. Is this normal for us uncirumsised hangers, if not how can I eliminate this problem?

I don’t own one, but looking at the design I see this a one of the problems with the Wench. It can’t grip the inner structures well and ends up gripping only the skin and sliding off. Are you able to close the cable clamp tightly (assuming you followed the design as put forth in this thread)? Not clamping tight enough might be part of the problem. Something was said about the initial placement in this thread which might help.

Originally Posted by westla90069
I don’t own one, but looking at the design I see this a one of the problems with the Wench. It can’t grip the inner structures well and ends up gripping only the skin and sliding off.

Westla-
Should you need help understanding the Wench design and how to direct people to properly use the device let me know. I’m always available to help.
In the meantime, a nice starting point might be this thread in which an experienced hanger points out that he can hang 15lbs with the Wench without a clamp. Another mentions hanging 25lbs. Hopefully that will put to rest any concern you might have that the Wench “can't grip the inner structures well and ends up gripping only the skin and sliding off”.
As I’m sure you know, any hanging device if used incorrectly will result in slippage.

Originally Posted by Xristo
the wrench will slide to just below my head, and when I touched my head it felt like it was going to explode. It was like I could pop it with a pin and it will burst like a balloon. Is this experienced by all hangers? Also, my skin over the top part of my base seemed to take most of the stretch. Is this normal for us uncirumsised hangers, if not how can I eliminate this problem?

Xristo-

Nine out of ten times when a person experiences severe engorgement of the glans it is due to their wrapping technique. Almost always it is because they are wrapping too tightly and essentially cutting off the outflow of blood - blood goes in, but cannot go out.
To solve this, try wearing your wrap loose enough so that you can urinate with it on.

How much or how little wrap material you use can also effect the quality of hold the Wench can achieve. What type of material(s) you use will also have an effect.

As for the skin stretch at the base of your shaft - this is completely normal and should be expected when a guy first begins hanging. You will need to stretch skin first before any other anatomy can be stretched. This can take a few days to a few weeks.

Be patient and experiment a bit. Take matters slow and use caution and you should be enjoying a good hang in no time.

Check out this post for more information about wrapping and the Wench.

—Cap

Xristro,

I am also uncut and I’ve been hanging with my wench for a few months.

Cap is right about the wrap, it took me about a week of solid experimenting to find the best way to wrap for the wench. I found that I could wrap much looser than I initially thought and it would hold much better. Also the grippers on mine certainly hold the internal structures, they are about 2 fingers wide, so it gets a good hold. However, it does move slightly towards my head when I attach the weight, but I think this is normal for all hangers.

In regard to the swollen head, I always squeeze a lot of the blood out of my glans (with the wench on)before attaching the weight, that way you can reduce/avoid the problem.

LB

Xristo,

I’m also an uncut wench hanger, and your wrapping technique is the problem.

As Cappy said, you’ve wrapped too tight.

As per Mr Lordbase, make sure you squeeze the blood out of your glans

And I would recommend you start with less weight so as to help you get your wrapping right. I began with 2.1lbs (about a kilo), kept practicing , wrapping, and then increased the weight slowly.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Long time no-gainer finally gained!sizemoorePenis Enlargement2101-17-2007 11:36 AM
I finally did itRBPenis Enlargement404-08-2003 09:50 PM

All times are GMT. The time now is 09:10 PM.