Built my overkill Turnbuckle Piet AFB!

I was thinking about using an all day stretcher with something like a couple pounds of pull from either a weight or elastic band. But since I already made some gains a few years ago (about 2”), and as some have pointed out in the forum, I might need heavy weight to make more gains. So I built me this stretcher. It has a 2” range by twisting the turnbuckles. They turn very easily and can put enough tension to rip off your dick if so desired. LOL! It can also be used with as little tension as wanted by simply turning the turnbuckles less. Also, you can adjust the angle it is pulling by turning one more than the other. It seems compact enough to use with pants as long as the pants are a little loose.

I first made one with paint stir sticks but that started to crack. This all steel and aluminum stretcher will not break!

BTW, the yellow is electrical tape. The stainless collar has two slots in it to allow it to be clamped to a pipe. The small slots could catch on skin if you rotated the device so I put some tape over the slots to prevent that. Later I will fill in the two narrow slots with epoxy and the tape will not be needed.

I tried it using a bad wrap job and it worked well. I’ll have to experiment with different wrap techniques to see what works best for sessions with strong tension.

Interesting design and it looks well build, however if you put pressure ontop of your shaft you will turn numb pretty fast. The attachment part should be rotated 90 degrees for lateral pressure assuming you want the turnbuckles left and right of your penis.

You could try attaching it with lateral pressure and then rotate the stretcher and your penis 90 degrees. Not sure if that works.

It is made to be used with lateral pressure like the other devices. The turnbuckle shafts are positioned above and below the shaft. That way you can swivel the rods to the right or left against your leg if you want to use it under your pants. You can also adjust the angle of the side clamping plates to better match the angle of the head by turning one more than the other. I like the lower shaft to be a little longer than the top shaft to make the plates better match the angle of the head.

Ah ok, it has been so long since I last used a stretcher that I can’t remember what works and what not. Sounds like it may work :)

Here is how it should be used. Turnbuckles on top and bottom, plates grip the right and left side of shaft.

6-8 - Is hanging worth trying after gains already made?

That looks a lot like the one I made last year.

Mine sure worked, but it will turn your head black if you don`t release it after about 30-35 minutes, because you have to have it on tight enough that the head doesn`t slip out when you really apply the stretch.

At least that was my experience, and I certainly couldn`t wear mine under pants, I wore mine in the bath for 1/2 hour at a time and stretched out as far as it would go without tearing my dick off.

hey a-unit I’m thinking and wanting to get a extender but really worried about getting jip off or just mess it up all together. if you don’t mind, you don’t have to and no hard fillings but if you could give or show me some instruction on how to build an extender or your extender. where to get the stuff etc. i seen you gain like an inch from a homemade extender. if anybody need to be followed in this pe game you are one of those people. but any way it could help me out a lot but if you cant i do understand. i just will have figure it out on my own.