Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Best way of hanging, some ideas

hello ticktickticker, I just got the Askina Elast band… :-) very happy… but I dont really understand how you use it. You said that you dont use sheaths?…

personnlay, I have the maxvac hanger and I have 2 sheaths left… the others just ripped so quickly.. (I really should find some other material maybe you know.. cause each time ordering those sheaths is a bit two expenssive for me.)

any how.. oh and do you throw away the tape after every use… I got a big pack with 20 small rolls inside…

thanks so much,

best wishes

dave

Hi ofirdavid123 - the roll the elastic band after use and reuse it until it looks dirty or starts to disintegrate.

I start with a few round about half an inch behind the glans then work my way to just behind the glans - pretty tight because you want to counteract the negative pressure which leads to fluid build up and blisters. From directly behind the glans I start to wrap the glans in crossing angles and make sure to make a round behind the glans every two rounds to make sure it stays well in place. Try to avoid any wrinkles. It takes a little time and practise.

I only use one sheet over the hanger and over my shaft (behind the wrap - I wrap so that all of my dick inside the hanger is covered with wrap.

I don’t know what other sheets are good - some one posted about stuff you find in sex shops - less expensive but less resistant also.


Later - ttt

Originally Posted by Sacred
Your right in some points.
A bib doesnt seem to give enough of a pull on my actual penis - being uncut - I get alot of the exertion going to my skin. Many would argue this is due to the way I wrap, but I have tried many forms of wrapping and all seem to cause so much pain and pinching to my skin in the bib that I had to stop after a maximium of 3x12min.

I’m uncut and use the bib hanger with no problems.. Trust me it’s your wrapping. You need to wrap TIGHT for it to work.

Originally Posted by ticktickticker
Hi ofirdavid123 - the roll the elastic band after use and reuse it until it looks dirty or starts to disintegrate.

I start with a few round about half an inch behind the glans then work my way to just behind the glans - pretty tight because you want to counteract the negative pressure which leads to fluid build up and blisters. From directly behind the glans I start to wrap the glans in crossing angles and make sure to make a round behind the glans every two rounds to make sure it stays well in place. Try to avoid any wrinkles. It takes a little time and practise.

I only use one sheet over the hanger and over my shaft (behind the wrap - I wrap so that all of my dick inside the hanger is covered with wrap.

I don’t know what other sheets are good - some one posted about stuff you find in sex shops - less expensive but less resistant also.

RE ttt ok thanks.. so you use 2 sheaths? one on the maxvac and one on your penis? (did I understand right?)
you get the hermetic sealing because that the sheat touches the skin? I mean the askina wrap is under the blue sheat which is on your penis and at the base it comes in contact with the skin so to keep the hermetic pressure? Because I cannot seem to get a seal with the askina wrap alone on my penis…
I hope I made my question clear.. yes it’s a little complicated…
thank you again
dave

I need to start using a wrap in order to vac-hang because of all the fluid buildup I get in my glans. However, I would really prefer not to use the taping technique simply because it sounds very time consuming, inconvenient, possibly painful (where you stick it to skin), etc.

Has anyone tried anything like Saran Wrap as first layer to cover glans as something to simplify things a little bit? Saran Wrap does stick to itself but not to skin, is very cheap, and would be easy to apply in one large piece?

VKN1,

Finger of a dish glove. I didn’t think it would fit but after a while it stretches enough to.

I’ve tried very hard to get the monkeybar constriction sleeve to work but it always creeps down a little bit during set and just generally is unable to support my tip, so the very tip gets very swollen, discolored, twisted, etc. I have decided it’s better to let the whole glans swell than to have just the tip go through all the abuse.

I figured a dish glove wouldn’t work much better because (a)it isn’t silicone so it would probably creep away leaving tip exposed even more than the very tacky/grippy silicone monkeybar sleeve. Have you not found that the tip still swells up considerably?

I try to get 3 pounds yesterday, and I have a problem with the sheath (I use medical glove), the longer the sheath, that will cover more shaft, the more it pulls the skin and cover half of the head. But if I don’t make it longer, it just can’t hold more than 10 minutes, it will slip due to lost of vacuum.

Do you guys have the skin pulled down and cover half of the head when you hang? WHat should I do to prevent this?

Today I tried SO, SL & SR, but I feel less stretch than SD with same weight, is this normal?

Originally Posted by vkn1
I figured a dish glove wouldn’t work much better because (a)it isn’t silicone so it would probably creep away leaving tip exposed even more than the very tacky/grippy silicone monkeybar sleeve. Have you not found that the tip still swells up considerably?

Well since the fingers of the glove are less stretch they tend to compress more. They will eventually wear out but then just cut another finger off and use that one. The tip does swell be in a different way, not as bad. The swelling goes down faster. I used to get blisters quite often. With the glove I’ve hung up to 15 lbs for 45 minutes and have not had a single one.

Have you used the monkeybar constriction sleeve? I find it always creeps, leaving my tip unsupported. This bothers me a lot because it means the urethral opening gets all the stress and it hurts just thinking about a blister there. Anyway, so the glove doesn’t slip away from tip for you? By the way, I would have already been trying the glove right now but I’ve got to take some time off because my glans is all dotted up and the dots seem to only get worse when I attempt to hang. I would like to hear your answers to these questions, though, because right now I’m pretty discouraged about my future with hanging.

MB constriction sleeves do creep up on me. I might have an earlier model though. The seem a bit small length wise as they barely cover the glans for me. The finger from the glove does slip eventually but it take much longer time for it to and it is very gradual. I am able to hang between 15-45 minutes wearing one. I find the easiest want to put one on is to clamp to full erection and then stretch the finger from the glove over the glans. I will take some practice. Just a side note that when you unclamp after the sleeve is on you might feel a bit of “pain” as the blood come out of the penis because the rubber on the glove will tend to pull on the head a bit and the glans decrease in size. I have foudn this very minimal and the benefits out weigh this brief inconvenience. You might also have to adjust the sleeve a bit after as well.

Is it not possible to use a condom as a constrictor sleeve? Granted it may not “constrict” all that much but how about some small ones?

Originally Posted by Sacred
Is it not possible to use a condom as a constrictor sleeve? Granted it may not “constrict” all that much but how about some small ones?

I would think that the latex would be too week to do any real help. It is way too pliable.

The original vachanger design by mbuc or mgus use condom

Top

All times are GMT. The time now is 02:54 AM.