Extending with large girth

I have owned a couple of extenders over the years with no success whatsoever. I think in total between the two of them, I’ve logged maybe two hours of use. I have found them to be extremely uncomfortable and ill fitting due to my girth. When flaccid, my mean girth is about 5.5” with a base girth of close to 6”. I have used the X4 wide base attachment and found it to be snug, but not constructive like the regular base, but it still got to be uncomfortable at times. I had issues with wrapping and the noose tended to slip.

Having said all of that, I have read tons of anecdotal evidence about extender use and gains made, and I want to really give it a shot. This year I’m really wanting to focus on link, or at least put more of an emphasis on it. Anyone out there with large girth have any tips for good extender use? Any suggestions on what extender to purchase?

Honestly, this is the same reason I got out of extending. I had the X4 and the larger base and while it worked well to start PE, I went back to extending last year…for all of 2 hours total, over 5 attempts. And ended up with a brand new one I don’t need from Size Genetics.

Short answer, I think you may need to facsimile a base and corresponding width bed for the glans and upper shaft for yourself if you’re serious about extending.

Any tips on how to make one of these? In my research, I’ve seen some homemade ones and honestly they looked like death traps.

Have you tried a piece of silicone hanger sleeve at the base like some guys use for clamping ?

It can effectively reduce your girth quite a bit depending on the size used.

My idea would be to make a new base out of a smooth wood, sanded and primed or stained. The key is in the pistons and head of the device. Once your base is made (a square piece of wood with a circle the size you comfortably fit through), you have options.

The twin circle pieces at the base where the pistons screw in must be secured. A mild bevel of a circular indent to fit both is key. You can try a combo of glue and rubber bands to hold them in the indentations.

The diameter between the two will determine how much modification the head will need but this is the easy part. If you have two beds, the regular and the quad bed, you can remove (with a small saw or dremel) the two rod cups from one and attach them in a way that gets the intact bed to fit between the two rod cups at the diameter set by your new base.

I’d have to try and facsimile pictures to demonstrate if my description is inadequate.

I modified my extender for all day use by gluing a screw between the retention bar holes. Then I looped rubber bands around the screw and a carabiner. The carabiner side latches to a dog collar that sits strapped just below my knee.

This modification not only avoids the strange bases for these devices but also allows all day use under jeans with decent comfort.

Add or remove bands as you see fit.

You read it here first folks, only a matter of time before it’s stolen and sold lol.

Hope it helps!

I need some kind of picture. That sounds more complex than I’m thinking it is and I can’t properly imagine it. Intriguing but…complicated sounding.

Sorry about the confusion. I’ll try and post a pic.

Top of pic is the setup. Side pic is the setup on body. Grey square indicates strap of extender on penis.

Hope this helps. It’s 7/10 comfy and shows a great bulge if you want it to. Manually adding bands means you get to control tension.

Going for my final inch this year for length and last half inch girth. Wish me luck.

Doesn’t look like the pic worked. Lemme try once more.

Oops, it was a .bmp which is not allowed.