The True Measurement

Lately, I’ve been looking at some of my cock pics and am just now realizing (shocking isn’t it) that my penis isn’t completely straight. This invariably means that my BPEL and EL measurements I have taken in the past cannot truly be accurate because if I measured along the slight arc, I should be a little bigger in both BPEL and EL. So, my question to you is one of protocol. If I use a cloth tape to measure my EL and my erection angle at its peak is approximately 1-2pm, should I apply a downwards force making sure that my penis is parallel to the ground and then measure even though I feels like this somehow makes me slightly smaller than if I left it at the angle it was. Or should I just keep it at its angle and try my best to measure from the bottom(part that connects to my body) of the shaft even though that spot now forms a “V”??? I am still going to meausre my BPEL and EL for consistency but I was wondering about cloth tape measuring protocol. Thanks.

It’s your call really. I have a similar situation and I put parallel to the ground when I measure.

It doesn’t matter as long as you find a consistent way to measure. If you want to know “truely” how big your penis is, then maybe a volume measurement would be better.

Pretty much the surveys say to straighten the penis out as much as you can. Just try not to squeeze it because I personally gain length that way. My flaccid stretch puts me at 8.1 ! So when I squeeze and reduce the girth it seems to add length.

My dick curves to the left, but I still use a wooden ruler for bone-pressed measurements and simply straighten my dick out as much as possible. While standing, I try and keep everything parallel to the floor so that I get consistent measurements. I only use tape measures when measuring girth or for non-bone-pressed length measurements.

Thanks for the responses guys. I guess it’s just because I want to reach 8NBP so bad that I’m looking for more and more accurate ways of measuring. It’ll be a shock to me if I meausure on Tue with a cloth tape and come to realize that I am already 8 inches and that the ruler has been giving me such an inaccurate measurment all along!

My erection angle is much higher than most, and I have an upward curve to boot. I simply cannot straighten out that curve well when I have a full erection, and the angle I get is very strong when fully erect. I had to compromise and use a cloth tape. But to keep things as legit as I can, I do the bone press with a wooden ruler, then slide the tape on top and hold it to the identical spot as the ruler end with my thumb. Remove the ruler, finish the measure. That way I don’t gain any phantom length by the softness of the tape.

Its scary..up until a few weeks ago I thought I would never need a rule bigger than 6 inches.

Life is good.

While a cloth tape will allow you to better follow the curve, you may find that you have trouble establshing a consistent start point or position for the tape. It is eassy for it to slip or flatten out, giving you an inaccurate number.

In my opinion the curve represents usable meat,

I’m trying to make my penis longer because I want to participate in creating a CDS type orgasm. I also curve upwards a bit. I place a small metal ruler on my penis when it is erect and push down just a little to get the final measurement. I like having a slight upward curve. It seems to mesh well with a slightly upward curving vagina…

Thanks for all the comments guy! Meausrement day tommorow! Wish me luck!