I have come up with a new ADS and am pretty excited about. It is an easy modification of a few items you can get at your local drug store plus a rubber band.
It doesn’t require any wrap underneath, is very stealth and can be comfortably worn for hours. I don’t work for Futuro but they make some great ADS materials!
What you will need
Futuro “Infinity” Precision Fit Wrist Support. It comes in a black box with item #01036 printed on it
Futuro Knee Strap or anything you want to wrap below your knee without cutting off the circulation
Heavy duty rubber band like the ones that come around a bundle of mail
1- Open the wrist support and lay it out flat on a table with the smooth light gray side facing up. You will see a sewn loop on the left end that you would normal put your thumb through and a tab with hook Velcro on the right end.
2- With scissors trim the top and bottom of the support off so it becomes a consistent width from the Velcro tab on the right all the way down to the other end where the loop is. Don’t cut the loop off, you will need it ! It should end up looking like a 12 inch strap with a loop sticking up on the left end
3- Use a half hitch knot to attach one end of the rubber band to the loop on the support strap
4- While lightly stretching your penis place the head on the soft light gray side of the support strap just below the loop. You can mess around with this location but I have found it is best to place your head as high up into the loop as possible. Wrap the support strap around your penis and spiral toward your base as you go just as you would wrap your penis for hanging. Secure the Velcro tab to the outer side of the support strap when you run out of material.
5- Thread the knee strap through the un attached end of the rubber band. Place the knee strap on your leg just below the knee as directed on the box. The rubberband should now be stretched out between the knee strap and the support strap that is wrapped around your penis.
You may need to play around with how tight you wrap your penis so you can maintain good blood flow. You can also use thicker or multiple rubber bands for a stronger pull or thinner bands for a lighter feel. This entire set up costs less than 20$ and can be made in about 5 minutes. Because it’s made from sports products no one will think it is a PE device if you happen to leave it lying around.
I hope you guys give it a try and send comments on how to improve the design.