Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

New auto jelqer design

123

I think Avogadro6022 is going somewhere with this. Are you using ProE or Wildfire modeling program. Have you considered using lexan as a material or have one made out of lithography as your first one although that might be a bit pricey for only one. I am interested to see what the out come of this is.

Originally Posted by Piet
Not sure if it’s an issue but I noticed the irisblades act as levers but in an opposite way, like closing a door by pushing near the hinge.


I am not sure what you mean.

Originally Posted by tntjockey
I think Avogadro6022 is going somewhere with this. Are you using ProE or Wildfire modeling program. Have you considered using lexan as a material or have one made out of lithography as your first one although that might be a bit pricey for only one. I am interested to see what the out come of this is.

I am actually using Blender 2.45, it is free and pretty easy to learn, especially for stuff like this. I have never considered lexan, but I will look into it.

These are instructions as to how to build your own iris. Read before starting.

1. Cut out three rings, A, B, and C.
2. Divide one of the rings into thirds and shape them into points at one end.
3. Grab Six nails
4. Punch a hole in both corners of the petal.
5. You should have three petals that look like picture A
6. Take ring B and punch 3 holes near the inner edge that are 120 degrees apart. (Refer to Picture B)
7. Here is the tricky part.
7a. put all of the petals in ring B like in picture C1
7b. for each outer nail. mark the spot on ring C that correlates to that nail if the petal was matching the contour of Ring B.
7c. Now turn the petals inward as much as you wish. then do the same marking for the outer nails, you should now have two points a starting point and an ending point for each nail.
7d. Draw a line between the two point and make a slit, then cut out the sides of the slit so that there is enough room for the nail to move without too much friction. (Refer to picture C2)
8. Place ring C on top the petals so they are sandwiched between C and B.

Turn either ring.

Alternatively you could use the cutouts I supplied.

Attached Images
picture A.jpg
(46.1 KB, 65 views)
picture B.jpg
(45.0 KB, 50 views)
picture C1.jpg
(42.3 KB, 48 views)
Picture C2.jpg
(46.7 KB, 53 views)
cutouts.jpg
(23.0 KB, 59 views)

Last edited by Avogadro6022 : 12-26-2007 at .

Originally Posted by ThunderSS
Where do the di-lithium crystals go?

Wow. It’s gonna be warp powered.

Maybe two or four “blades” would help to focus the pressure on the sides of the penis, away from the dorsal nerve.

If you extend the blades outside, and have a way to attach rubber bands that might be a way to adjust the pressure…

Just some quick thoughts.


Sept. 4, '07: BPEL 6.875 inches, EG widest 5.25

Goal: Double digits

hello,

very interesting!

nice project

Top
123

All times are GMT. The time now is 08:19 PM.